Automatic Swing Door Operator DFA 127 Operating instructions E

Status and fault signalsStatus 60:Status 61:Status 62:Status 72:Status 88:Status 89:Status 90:Status 91:Status 92:Parameter memory (EEPROM) defectiveChange control unitReset by service fitterSSK active longer than 60 sAutomatically reset if in order, or by service fitterBDE has no priorityBecause a higher-level signal is presentAutomatically reset on release of BDE-buttonSlave connectionMaster has no connection to Slave operatorReset by service fitterDifference parameterThe common parameters of M/S operators do not correspond toeach other.Reset by service fitterMaster connectionSlave has no connection to master operatorReset by service fitterRailbeam active > 60 sec.Automatically reset if everything is in order, or by service fitterBodyguard active > 60 sec.Automatically reset if everything is in order, or by service fitterSTG relay defectiveReplacement by service fitterStatus 93: Overvoltage 24 V (from 27V)Status 94:Status 95:Status 96:Status 99:Status 105:Spring calibrationAutomatic resetError in sense of rotationEEPROM voidOperator rotatesThe grease in the gear will be dispersed.Automatic resetTest brakeAutomatic resetOperating instructions DFA 127 Full Power Rev. B 11/2006 Page 19 of 20