RS-130-DP Installation Guide - car alarm

More documents

Recommendations

Info

12 Wire Secondary Harness (cont’d)Yellow - Alarm Ignition Control (+) OutputThis output controls the ignition input to an outboard aftermarket alarm or keylessentry. When remote start is activated, this wire prevents the keyless/alarm fromreceiving an ignition ON input to allow for keyless entry operation. Otherwise, it’s adirect pass through of the ignition circuit.CONNECTION: Connect this wire directly to the outboard keyless entry/alarm’signition input wire.Lt. Green/Red Wire - OEM Alarm Arm (-) OutputThis output provides a 250mA negative pulse when remote start is turned off andwhen the system’s alarm is armed.CONNECTION: Connect this wire to the vehicle’s OEM alarm arm circuit. Typically,it will show ground when the door cylinder key is turned to the lock position.Lt. Green/Black Wire - OEM Alarm Disarm (-) OutputThis output provides a 250mA negative pulse when remote start is activated andwhen the system’s alarm is disarmed.CONNECTION: Connect this wire to the vehicle’s OEM alarm disarm circuit. Typically,it will show ground when the door cylinder key is turned to the unlock position.3 Pin Satellite Relay Port (RED)Green Wire - Start (-) Programmable OutputThis output provides a 250mA negative pulse when the large VIOLET start wire isactive. It can also be programmed for PULSE AFTER START, STATUS, or DOME-LIGHT SUPERVISION. See installer programmable feature #4.CONNECTION: If a negative start output is needed, connect this directly to the vehicle’snegative starter circuit. Otherwise, use a relay (or RS-RP module) to convertthis to a high current circuit.Red Wire - Constant (+) OutputThis output provides a 500mA positive output to drive the positive pin of addedrelay coils.Blue Wire - Ignition (-) OutputThis provides a 250mA negative output that mimics the large PINK ignition wire’soperation.CONNECTION: This is typically used to activate immobilizer bypass modules or toadd extra ignition circuits with the addition of a relay.8
Green Data PortThis port provides a direct digital interface for any Omega IntelliKit or OmegaLinkinterface modules. It can eliminate the need for several wire-to-wire connections.Refer to the wire diagram overview on page 6 to see which circuits are supported bythis port and compare them to the data functions available from the interfacemodule. This port is using our standard D2D (Trilogix) protocol.Status LightsThis system includes a status light that is typically mounted in the dash somewhere.It is desirable for it to be visible from as many angles around the vehicle aspossible for maximum visual theft deterrence.Valet / Programming SwitchThis system includes a valet switch that is built into the window mount antennamodule. The control module has a separate port for the valet switch, so an optionalcustom mounted switch can be used if desired.9
Page 1: RS-130-DPDeluxe Keyless Entry & Rem
Page 4 and 5: 6 Pin Main Wire Harness (cont’d)O
Page 6 and 7: Wiring OverviewStatusLightValetSwit
Page 10 and 11: Tach ProgrammingWhen utilizing the
Page 12: Back CoverColor cover is in asepara

RS-130-DP Installation Guide - car alarm

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?