Wiring Diagram of 6A - Lextreme.com

More documents

Recommendations

Info

10 INSTALLATION INSTRUCTIONS5. Tap the White wire to ground several times. Each time you pull the wire from ground, aspark should jump from the coil wire to ground. If spark is present, the ignition is workingproperly. If there is no spark skip to step 6 below:If triggering with the Magnetic Pickup:MAGNETIC PICKUP TRIGGER1. Make sure the ignition switch is in the "Off"position.2. Remove the coil wire from the distributor capand set the terminal approximately 1/2" fromground.3. Disconnect the MSD magnetic pickup wiresfrom the distributor.4. Turn the ignition to the On position. Do not Figure 9 Checking for Spark with Magneticcrank the engine.Pickup.5. With a small jumper wire, short the MSD's Green and Violet magnetic pickup wirestogether. Each time you break this short, a spark should jump from the coil wire toground. If spark is present, the ignition is working properly. If there is no spark skip tostep 6 below:6. If there is no spark:A. Inspect all of the wiring.B. Substitute another coil and repeat the test. If there is now spark, the coil is at fault.C. If there is still no spark, check to make sure there is 12 volts on the small Red wirefrom the MSD when the key is in the On position. If 12 volts is not present, findanother switched 12 volt source and repeat the test.D. If, after following the test procedures and inspecting all of the wiring, there is stillno spark, the MSD Ignition is in need of repair. See the Warranty and Servicesection for information.The following wiring diagrams illustrate numerous installations on different vehicles andapplications. If you experience difficulties when installing your MSD, contact our CustomerSupport Department at (915) 855-7123 (8 - 5 Mountain time) or e-mail us at:msdtech@msdignition.comMSD SYSTEMS Installing to Points/Amplifier Style Ignition.NOTE: On dual point setups, it is recommendedto remove the trailing set of points.NOTE: Ballast Resistor is not necessary.AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
INSTALLATION INSTRUCTIONS 11MSD SYSTEMSInstalling to an MSD Distributor/Crank Trigger.MSD SYSTEMS Installing to an MSD Distributor PN 8360.NOTE: The ignition module of the PN 8360still triggers the MSD.AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
Page 3 and 4: INSTALLATION INSTRUCTIONS 3Routing:
Page 5 and 6: INSTALLATION INSTRUCTIONS 5Grounds:
Page 7 and 8: INSTALLATION INSTRUCTIONS 7TROUBLES
Page 9: INSTALLATION INSTRUCTIONS 9Most oth
Page 13 and 14: INSTALLATION INSTRUCTIONS 13MSD SYS
Page 15 and 16: INSTALLATION INSTRUCTIONS 15GM IGNI
Page 17 and 18: INSTALLATION INSTRUCTIONS 17GM IGNI
Page 19 and 20: INSTALLATION INSTRUCTIONS 19FORD IG
Page 21 and 22: INSTALLATION INSTRUCTIONS 21CHRYSLE
Page 23 and 24: INSTALLATION INSTRUCTIONS 23AFTERMA

Wiring Diagram of 6A - Lextreme.com

Create successful ePaper yourself

Delete template?

Save as template?