ECOlastic - Tremco Roofing

ECOLastic ®A Water-based, Asbestos Free Treatmentfor Maintaining Built-Up Roof MembranesComposition: ECOLastic® is an emulsifiedblend of special aromatic oils and additives formulatedto be compatible with both tar andasphalt built-up roof membranes. ECOLastic isasbestos free.Basis Use: Formulated to maintain weathereddry roof membranes and improve self-healingcharacteristics of coal tar pitch. Effectivelyrestores pliability of built-up roof bitumens.Recommended for use as surfacing adhesive fornew asphalt and gravel constructions, for newtar and gravel roofs, and for new modified bitumenroof systems.Limitations:• ECOLastic is not intended for use in protectedmembrane assemblies.• Store above 0°C (32°F).• Do not apply to roofs having a slope greaterthan 16% (2:12).• ECOLastic is not intended to be used onsmooth asphalt roofs as a smooth surfacetreatment.• Not intended for application over modifiedbitumen membranes as part of a TremcoRestoration Warranty.• Do not apply below 7°C (45°F) or when rainappears imminent.FeaturesCompatible bitumenAsbestos free,solvent free andecologically cleanCold-appliedProduct AdvantagesBenefits• Can be used on bothtar and asphalt built-uproofs• Minimal odor• Air pollution minimized• Safe to use. Fire hazardsgreatly reducedPackaging: ECOLastic is available in 19L and208L (5 and 55 gallon) containers. 1880 L (500gal) tote tanks are available on special orderbasis.Grade: Spray/brush. Recommended sprayequipment: Minimum 11:1 ratio pump with3.9 - 4.4 mm (.156” to .172”) spray tip.Storage Life: One year in unopened container.APPLICATION DATAMaintenance and Restoration: Remove loosegravel, dirt, dust, rotted felt, and foreign matter.Roof must be clean. Repair flashings,defects, breaks, and weak areas. Roof must bewatertight. Apply ECOLastic. Immediatelybroadcast aggregate surfacing.For New Asphalt-Based Roof Use: Apply TypeIII asphalt at approximately 1.5 kg/m 2 (30lb/sq.). Apply protective coating of ECOLastic.Promptly cover with fresh roofing gravel at 19-25 kg/m 2 (400-500 lb/sq.). Gravel surfacingshall conform to ASTM D 1863-86.For New Tar-Based and Modified BitumenRoof Usage: Consult your local TremcoRepresentative for specific recommendations.Coverage: Coverage rates will vary dependingon actual surface conditions. For maintenanceuse — 2.8 L/m 2 (7 gal/sq.) minimum. For newroof use — 2.0 L/m 2 (5 gal/sq.) minimum.Equipment Clean-Up: Clean with soap andwater immediately after use.Precautions: Users must read container labelsand Material Safety Date Sheets for health andsafety precautions prior to use.Availability and Cost: Contact your localTremco Roofing Representative for pricing andavailability. For the name and number of yourRepresentative, call the Roofing Division at216/292-5000.UL approved• Fire protectionRoofing & Weatherproofing Peace of Mind

Maintenance: Your local Tremco RoofingRepresentative can provide you with effectivemaintenance procedures which may vary,depending upon specific conditions. Periodicinspections, early repairs and preventive maintenanceare all part of a sound roof program.Guarantee/Warranty: Tremco Inc. warrantsECOLastic to be free of defects and to meetpublished physical properties when testedaccording to ASTM and Tremco standards.Under this warranty, any ECOLastic productthat is proved to be defective when applied inaccordance to our written instructions, and inapplications recommended by Tremco as suitablefor this product will be replaced with likeproduct at no charge. THIS IS BUYERS SOLEAND EXCLUSIVE REMEDY.All claims concerning product defects must bemade in writing within twelve (12) months ofshipment. The absence of such claims in writingduring this period will constitute a waiver ofall claims with respect to such product.This warranty shall be IN LIEU OF any otherwarranty, express or implied, including but notlimited to, any implied warranty of MER-CHANTABILITY OR FITNESS FOR A PARTICULARPURPOSE.Technical Services: Your local TremcoRepresentative, working with the TechnicalService Staff, can help analyze conditions andneeds to develop recommendations for specialapplications. The services of the TremcoResearch Center, which has earned a uniquereputation in weatherproofing technology,complement and extend the services of theTremco Technical Service staff.Statement of Policy and Responsibility:Tremco takes responsibility for furnishing qualitymaterials and for providing specifications andrecommendations for their proper installation.As neither Tremco itself nor its Representativespractice architecture or engineering, Tremcooffers no opinion on, and expressly disclaimsany responsibility for the soundness of anystructure on which its products may be applied.If questions arise as to the soundness of a structureor its ability to support a planned installationproperly, the Owner should obtain theopinion of competent structural engineersbefore proceeding. Tremco accepts no liabilityfor any structural failure or for resultant damages,and no Tremco Representative is authorizedto vary this disclaimer.Physical Performance CharacteristicsECOLastic®Property Typical Value Test MethodAsbestos content None ASTM D 276-00Density @ 25°C 1030 kg/m 3 ASTM D 1475-98(77°F)8.6 lb/galVolatile organic 29 g/L ASTM D 3960-05contentWater content 40% ASTM D 3792-05Penetration of Prominently visible TRC 712tar feltsamount of coatingbetween each felt.Top 3 felts bondedtogether so thatseparation causes themto tear. For 3rd and4th treated felts MVTshall be 12 g/100in 2/24 hrs. max.Wash-off resistance Passes TRC 709Freeze/thaw stability Usable after 10 cycles TRC 710Low temperature No cracking or loss TRC 715flexibility @ 7°C of adhesion(45°F)Gravel stain No staining of gravel TRC 717except bottom layersin intimate contactwith materials.TRC - Tremco Research Center - Standard Test(procedure used is available)3735 Green RoadBeachwood, OH 44122216-292-5000220 Wicksteed AveToronto, ONT M4H 1G7416-421-3300R-751601A Rev 1/09Printed in USA