Cable drag chain systems Overview - Eegholm

Strain relief systemsMurrplastik recommendationsThe strain relief plate shouldbe fitted with two power cableties on each side of the cableand secured approx. 20 to 30x cable diameter from the lastmoving chain link.The strain relief is suitable forcables up to 40 mm diameter.All electric cables must berelieved of strain at both themoving and fixed end. Forlonger travel distances (glidingapplication) a strain relief on oneside at the moving end is recommended.Care must be takento ensure the pressure only beapplied to a wide surface of thecable outer jacket.The clamping must be executedin such a way that the individualcores in the cable are notsquashed, but the cable shouldstill be held tightly.Hydraulic and pneumatic conduitsonly have to be strainrelieved at one end.Double strain relief platesStrain relief for the cables entered into the cable drag chain can also be achieved througha doubled setup using spacer sleeves. This variation of strain relief allows for an increasedpacking density.Strain relief plate ZLType Order no. Fits cable drag chain type PackZL...ZL 39 87701014 MP 25037G/MP 44045/MP 66045 1ZL 60 87701016 MP 25062G/MP 35032/MP 36062/MP 43062 1MP 44062 / MP 66062ZL 80 87701015 MP 43082/MP 44082/MP 66082 1ZL 87 87701018 MP 25087G/MP 35086/MP 36086 1ZL 103 87701020 MP 25101G/MP 35102/MP 36102/MP 43107 1MP 44107 / MP 66107ZL 121 87701022 MP 25125G/MP 35125/MP 36125 1ZL 140 87701024 MP 35150/MP 43142/MP 44142/MP 66142 1ZL 180/6 87701026 MP 43182 / MP 44182 1ZL 180/8 87701027 MP 66182 1If the strain relief plate is to be fitted directly on the chain bracket, the holedimensions of the strain relief plate should be taken as the basis.74