van Aaken SmartBox™ F Installation Instructions - 4 Wheel Online

van Aaken SmartBox FPowerstroke V8 6.0L Installation instructionsThere is a small groove (keyway) cut into thethreaded metal section of the switch. Thisgroove can be used to decide the orientationof the switch.Power positions are:• Switch towards the keyway : Fullpower position• Switch in the middle : Lower powerposition• Switch Away from the keyway : Unitis turned off (no power gain)Switch Operation• If no switch is connected to the van Aaken SmartBox F the default setting will be Power 2 – it will givemaximum extra power all the time.• If the included 3-position switch is connected the unit can be switched between Off, Power 1 and Power 2.Power 1 will typically give half the gain of Power 2 but this is entirely dependent on the tuning file programmedinto the unit. If in doubt about the function of each switch position please contact your SUPPLYING dealer.6) After Fitting and Before Starting the Vehicle – Please ReadPlease check :• All connections are firmly made• All wiring is adequately secured so as not to comeinto contact with sharp edges or moving parts.• The van Aaken SmartBox F is securelymounted.• No tools have been left in the engine bay.van Aaken SmartBox F INSTALLATION IS NOW COMPLETEThe van Aaken SmartBox F for Ford Powerstroke 6.0L is a high performance product that will change theoperating characteristics of your engine. When using this product, as with any performance increasing product,we would strongly recommend the use of EGT (Exhaust Gas Temperature) and Manifold Boost pressure gaugesto monitor conditions within the engineStart the vehicle in the usual mannerYou are now ready to experience van Aaken SmartBox power!IN THE UNLIKELY EVENT THAT THE VEHICLE WILL NOT START1 Check all of the plug-in connections to make sure they are pushed all the way home.2 Ensure that the van Aaken SmartBox F wiring harness has not been accidentally damaged.3 Ensure that no pins have been dislodged during the connection of the large plugs – To do this disconnect theECU plugs and visually inspect the pins on both the male and female side to ensure that none have been bent orpushed back in their socket.4 Make sure that no other connections in the engine bay have been disturbed accidentally.If you can find nothing wrong and the vehicle will still not start, contact your supplier or contact van Aaken Developmentsdirectly stating where and when your van Aaken SmartBox F was purchased.van Aaken Developments USA LLC4490 Valenty Rd., Suite CChubbuck, ID 83202Phone: (208) 234-5660 Fax: (208) 637-0287Website: www.vanaaken.com Email: usa@vanaaken.com