Fillets

More documents

Recommendations

Info

Fillet Featuresfile://C:\Documents and Settings\wentao.HKUST\Local Settings\Temp\~hh8F1F.htm9/7/2010NextCreating the GripNow you create the grip of the knob.1. Click Right on the Standard Views toolbar.2. Select the Right plane in the FeatureManager design tree, then click Extruded Boss/Base on theFeatures toolbar to open a sketch.3. Sketch four lines approximately as shown to create the profile. Do not create any inferencedperpendicular relations between lines.4. Add a Collinear relation between the vertical sketch line and the model edge as shown.5. Dimension as shown.6. Click Exit Sketch on the Sketch toolbar.
Fillet Featuresfile://C:\Documents and Settings\wentao.HKUST\Local Settings\Temp\~hh8F1F.htm9/7/20107. In the PropertyManager, under Direction 1:Select Blind in End Condition. Set Depth to 5.8. Click OK to create the extrude.NextAdding Draft to the GripYou add draft to taper the grip, giving it an aesthetically pleasing design in the finished part.1. Click Dimetric on the Standard Views toolbar.2. Click Draft on the Features toolbar.3. In the PropertyManager:Select Neutral Plane in Items to Draft. The neutral plane is the plane or face that you chooseto determine the pull direction when creating a mold. The Z axis direction of the neutral plane isthe direction in which the part ejects from the mold. Set Draft Angle to 10°.Select the Right plane for Neutral Plane, using the flyout FeatureManager design tree.a. In the upper left corner of the graphics area, click the plus sign to expand the designtree.b. Select the Right plane.Click in Faces to Draft, then select the three faces shown.4. Click OK to create the drafts.Congratulations! You have finished building the part used in the Fillet Features tutorial. Click here to go to the FilletFeatures tutorial.Creating a Face Fillet
Page 1 and 2: Fillet Featuresfile://C:\Documents
Page 3: Fillet Featuresfile://C:\Documents

Fillets

Create successful ePaper yourself

Delete template?

Save as template?