Universal Small Block Mopar/318/340/360 Carbureted System

More documents

Recommendations

Info

This Page Left Intentionally BlankP/N: 4809658©2006 Paxton AutomotiveAll Rights Reserved, Intl. Copr. Secured23MAR06 v1.0 UnivSBMCarb(4809658v1.0)2-2
Section 3OIL FEED INSTALLATION3.1 OIL FEED INSTALLATIONA. The supercharger uses engine oil for lubricationand must have an oil feed line connectedto a filtered oil access on the engine.B. Remove the 1/4"NPT oil pressure sendingunit from the engine block (next to the distributor).Install the supplied 1/4"NPT streetTEE into the block. Install the oil pressuresender into the end of the TEE. Install the1/4" x -4 fitting into the branch of the TEE.Position the fitting so that the opening facesthe passenger’s side/rear of the engine. (SeeFig. 3.1-a.)*** NOTE ***Use clean engine oil on the pipe threads. Teflon tapeand sealant is NOT recommended as it might loosenand cause blockage of the small oil feed orificeresulting in supercharger failure.C. Attach the 90° end of the supplied -4 braidedoil feed line to the installed fitting. (SeeFig. 3.1-a.) Secure the hose with the tiewrapsprovided, routing it away fromexhaust heat, chafing and/or sharp objects.Temporarily cover the open end from debrisuntil the connection is made to the supercharger.FACTORY SENSORINSTALLED INTO SUPPLIEDSTREET TEEFig 3.1-a.3-1P/N: 4809658©2006 Paxton AutomotiveAll Rights Reserved, Intl. Copr. Secured23MAR06 v1.0 UnivSBMCarb(4809658v1.0)
Page 1 and 2: S U P E R C H A R G E R SOwner’s
Page 3 and 4: Proper installation of this system
Page 5 and 6: TABLE OF CONTENTSFOREWORD . . . . .
Page 7 and 8: S U P E R C H A R G E R SSmall Bloc
Page 9 and 10: Congratulations! You have purchased
Page 11: 2.1 PREPARATION/REMOVALA. Disconnec
Page 15 and 16: Section 4OIL DRAIN INSTALLATION4.1
Page 17 and 18: Section 5MOUNTING BRACKET/SUPERCHAR
Page 19 and 20: K. Attach the alternator stay to th
Page 21 and 22: Section 6CRANK PULLEY AND SUPERCHAR
Page 23 and 24: Section 7AIR INLET DUCTING INSTALLA
Page 25 and 26: 8.1 CARBURETOR MODIFICATIONSA. If y
Page 27 and 28: Section 9DISCHARGE INSTALLATION (OP
Page 29 and 30: 10.1 FINAL REASSEMBLY AND CHECKSect

Universal Small Block Mopar/318/340/360 Carbureted System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?