WARNING! Please read and understand this owner's ... - Sig Sauer

More documents

Recommendations

Info

Maintenance9 Pistol maintenanceWARNING!Pistol is ready to firePossibly death or serious injuries5. Depress slide catch lever to close slide.6. Rotate takedown lever 16 clockwise 180° untilit points forward (see Fig. 14).16• Magazine must be removed from the pistol.• Before field stripping your pistol for cleaning,verify again that it is not loaded (see sections6.7 and 6.8).• Do not put your fingers into the slide.9.1 Field stripping the pistolProcedure:1. Unload pistol (see sections 6.7 and 6.8).2. Remove the threaded cap of the Silencerversion (see chapter 7.2.1), resp. thecounterweight of the Sport version (seechapter 7.1.1).3. Retract slide 4 fully and lock open by engagingthe slide catch lever 18 (see Fig. 13).Fig. 147. Retract slide fully; lift rear of slide until clear offrame and slowly move slide group forwardtowards muzzle end of pistol (see Fig. 15 andFig. 16).4181.Fig. 152.Fig. 134. Check to ensure there is no round in thechamber.Fig. 1617 US 06.01
Maintenance8. Remove slide assembly (slide, recoil springguide and recoil spring) from the barrelmuzzle.This level of stripping is sufficient for a thoroughcleaning after firing.CAUTION!Possibly damage to the pistol• Further dismantling of the pistol may only becarried out by qualified armorers andgunsmiths.9.2 Cleaning the pistolCAUTION!Possibly damage to the pistol• Never clean the barrel from the front (muzzleend) and never use steel brushes, as thesecan damage the smooth surface of the barrel.Use a suitable cleaning rod and brushdesigned for .22 caliber.• Solvents can damage the surface of thepistol. Before using a cleaning or solventagent, take note of the instructions andwarnings provided by the manufacturer.Procedure:1. Moisten cleaning brushes with gun oil andinsert into the barrel through the chamber.Carefully remove all powder residue and dirt inthe barrel and chamber with the cleaningbrush.2. Remove powder residue and oil using from thechamber and barrel using a cleaning patch.3. Clean external surfaces of the barrel with abrush that has been moistened with gun oil.4. Wipe off frame, slide, recoil spring guide andrecoil spring with a cloth lightly coated with gunoil or grease.5. Lightly oil barrel bore and chamber. Be sure toremove excess lubricant.3a/b 42151a51Fig. 17, Cleaning Standard version06.01US18
Page 1 and 2: WARNING!Please read and understand
Page 3 and 4: General instructions1 General instr
Page 5 and 6: Safety regulations2.1 Safety indica
Page 7 and 8: Product description3 Product descri
Page 9 and 10: Safety mechanismsHandling2. Remove
Page 11 and 12: Handling6.4 Loading the pistol (rea
Page 13 and 14: Handling6.6 Reloading during firing
Page 15: Sight6. Place the screw 58 in the f
Page 19 and 20: Maintenance9.4 Functional checkNote
Page 21 and 22: ServicingPart/fault Possible cause
Page 23 and 24: Scope of supplyAccessories11 Scope
Page 25 and 26: List of replacement partsFig. 20, S

WARNING! Please read and understand this owner's ... - Sig Sauer

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?