material safety data sheet - Ryko Car Wash Manufacturing Company

MATERIAL SAFETY DATA SHEETRYKO RAINSHIELDPage 1 of 3RYKO MANUFACTURING CO.11600 NW 54TH AVE.GRIMES, IA 50111515-986-3700EMERGENCY PHONE NO.: CHEMTREC 1-800-424-9300 (U.S. and Canada)SECTION I - PRODUCT INFORMATIONPRODUCT NAME: RYKO RAINSHIELD NFPA Ratings (Scale 0-4)PRODUCT PART NUMBER(S): 27200-000, 27200-001, 27200-002 Health: 2CHEMICAL NAMES AND SYNONYMS: N/A Flammability: 1CHEMICAL FAMILY: Surfactant mixture, aqueous Reactivity: 0FORMULA: Proprietary (Trade Secret)Other: NoneSECTION II - HAZARDOUS INGREDIENTSComponent CAS Number Percent * Hazards/Adopted ValuesQuaternary soya/coco amidoamine * None establishedHexylene glycol 107-41-5 * 25 ppm Ceiling Value (OSHA - PEL)25 ppm - (ACGIH TLV)Glycerin 56-81-5 * 10 mg/M 3 MistSECTION III - PHYSICAL DATABOILING POINT: 208 0 F SPECIFIC GRAVITY: 0.99FREEZING POINT: N/EVOLATILE BY WEIGHT: N/EVAPOR PRESSURE: N/EEVAPORATION RATE: N/EVAPOR DENSITY (AIR = 1): N/ESOLUBILITY IN WATER: SolublepH: 7.3APPEARANCE & ODOR: Clear to amber liquid. Strawberry Scent.SECTION IV - FIRE AND EXPLOSION HAZARD DATAFLASH POINT: >200 º FFLAMMABLE LIMITS (% volume in air): LEL: N/E UEL: N/EEXTINGUISHING MEDIA: Use dry chemical or carbon dioxide on small fires. Use foam (alcohol, polymer or ordinary) andwater spray on larger fires.SPECIAL FIRE FIGHTING PROCEDURES: Clear fire area of unprotected personnel. Do not enter confined fire space withoutfull bunker gear. Include a positive pressure NIOSH approved self-contained breathing apparatus and protective clothing.Cool fire exposed containers with water.UNUSUAL FIRE AND EXPLOSION HAZARDS: NoneMSDS # 15419-125Product # 27200-000, 27200-001, 27200-002REV: - ECO: 0906-044APRV: MM DATE: 9/19/06

MATERIAL SAFETY DATA SHEETRYKO RAINSHIELDPage 2 of 3SECTION V - HEALTH HAZARD DATAEFFECTS OF OVEREXPOSUREEye Contact: Product may cause temporary irritation to the eyes.Skin Contact: Product may cause temporary irritation to the skin.Inhalation: Product may be slightly irritating to mucous membranes.Ingestion: Product may cause irritation when ingested.EMERGENCY AND FIRST AID PROCEDURESEye Contact: Immediately flush with plenty of water for a least 15 minutes while occasionally holding the eyelids open to ensure flushingof the entire eye surface. Get medical attention, if necessary.Skin Contact: Flush affected area with water and wash with soap; remove contaminated clothing and shoes and do not reuse untilthoroughly cleaned. Skin cream applied after washing may relieve dryness. Should symptoms develop or persist, contact physician.Inhalation: Remove victim to fresh air; provide oxygen if breathing is difficult. If irritation develops or breathing becomes difficult,obtain medical attention.Ingestion: DO NOT INDUCE VOMITING! * Rinse mouth with water; give large quantities of water or milk to drink. If vomitingoccurs spontaneously; keep head below hips to prevent aspiration. Give more liquids. Do not give anything by mouth to anunconscious or drowsy person. Get immediate medical attention.* Because rapid absorption may occur through lungs if aspirated and cause systemic effects, the decision of whether to induce vomiting ornot should be made by a physician.OTHER INFORMATION: Preexisting eye, skin, and respiratory disorders may be aggravated by exposure.SECTION VI - REACTIVITY DATASTABILITY: X STABLE UNSTABLEINCOMPATIBILITY: NoneHAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition or combustion may produce carbon dioxide and/orcarbon monoxide, and/or oxides of nitrogen.HAZARDOUS POLYMERIZATION: WILL OCCUR X WILL NOT OCCURCONDITIONS TO AVOID: None.SECTION VII - SPILL AND LEAK PROCEDURESSTEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Caution: Material is slippery on wet or hard surfaces.Small Spills: Take up with sand or other non-combustible absorbent material and place into containers for later disposal. Wash area withsuitable detergent and thoroughly rinse.Large Spills: Dike far ahead of spill for later disposal and recovery.WASTE DISPOSAL METHODS: Recover material or dispose (incineration is preferred) in accordance with all applicable federal, state andlocal regulations. Material collected with absorbent may be disposed of in a permitted landfill in accordance with federal, state and localregulations. Empty containers may retain vapor or product residue. Observe all labeled safeguards until container is cleaned,reconditioned or destroyed.SECTION VIII - SPECIAL PROTECTION INFORMATIONRESPIRATORY PROTECTION: Not required.VENTILATION REQUIREMENTS: None required.EYE PROTECTION: Chemical goggles, or face shield required to prevent eye contact when handling open chemical containers or whenworking on equipment components containing this concentrated product.GLOVES NOT REQUIRED: However, if chemical comes in contact with skin, wash the affected area within 15 minutes.OTHER PROTECTIVE MEASURES: No protection is necessary during normal car wash operation.MSDS # 15419-125Product # 27200-000, 27200-001, 27200-002REV: - ECO: 0906-044

MATERIAL SAFETY DATA SHEETRYKO RAINSHIELDPage 3 of 3SECTION IX - DOT SHIPPING INFORMATIONProper Shipping Name: RYKO RAINSHIELDHazard Class: Non HazardousID Number: N/ALabel Requirements: N/AReportable Quantity: N/ASECTION X - SPECIAL PRECAUTIONSPrecautions to be taken in handling and storing: Do not get into eyes, on skin/clothing. Do not breathe concentrated vapors. After usingproduct, wash with soap and water before eating, drinking, smoking or using toilet facilities. Launder contaminated clothing before reuse.Store in tightly sealed containers when not in use. Store in well ventilated areas at temperatures below 120 0 F. As a general rule, preventand protect this product from unauthorized use. For commercial use only.SECTION XI - TOXICOLOGY INFORMATIONEyes: UnknownSkin: Non-corrosiveIngestion: Oral rat, LD50: 52,000 mg/KgInhalation: TLV: Not establishedCarcinogenicity: NTP, IARC, OSHA: Not listedMSDS # 15419-125Product # 27200-000, 27200-001, 27200-002REV: - ECO: 0906-044