W124 rear wheel axle shaft & bearing removal.pdf

More documents

Recommendations

Info

3 Remove, install brake calliper (111) andsuspend on a hook (41-120).Installation noteReplace self-locking hexagon bolt. Install brakehose and, on vehicles with ASR, install electriccable of wear indicator (111h) without twisting.P35-5461-134 Remove, install brake disk (111c) (42-228).Installation noteReplace self-locking hexagon socket bolt (111d).P35-5518-135 Remove, install brake shoes (112) of parkingbrake (42-530).P35-5519-136 Using extractor/pulling-in equipment (010)140 589 03 61 00 with set bolt (010b) and thrustpiece (010a), pull rear axle shaft flange (10) out ofangular-contact ball bearing (8) and remove.
7 Wheel carrier8 Two-row angular-contactball bearing10 Rear axle shaft flange010 Extractor/pulling-inequipment010a Thrust piece010b Set bolt010c Threaded bolt010d Support plateP35-5889-33Installation noteUsing extractor/pulling-in equipment (08a, 08b, 08cand 08e) 124 589 05 43 00 draw rear axle shaftflange (10) into two-row angular-contact ball bearing(8).MDuring the pulling-in process, the thrust washer124 589 05 43 00, part 03 (08c) must fit tightlyagainst the bearing inner race (arrow). In the case ofthe two-row angular-contact ball bearing, use thethrust washer side of 45 mm dia. (smaller dia.) andin the case of the two-row angular-contact rollerbearing, use the thrust washer side of 49 mm dia.(larger dia., T-model only).7 Wheel carrier8 Two-row angular-contactball bearing9 Circlip10 Rear axle shaft flange08a Hexagon bolt with collar nut08b Extractor/pulling-in sleeve08c Thrust washer (small,45 mm dia.)08e Thrust bearingP35-5530-35
Page 1 and 2: 35-130 Removal and installation of
Page 3: 140 589 00 01 00 201 589 00 01 00No
Page 8: Testing12 Check all parts to make s

W124 rear wheel axle shaft & bearing removal.pdf

Create successful ePaper yourself

Delete template?

Save as template?