Datatrac 400 Operations Manual - Aeroflex

Aeroflex Operation ManualSECTION III3.0 RECEIVE MODEThe receive mode consists of a primary setup screen, a secondary setup screen (referred to as the"Defaults" screen) and a real-time data display screen. There are also various help screensassociated with each setup parameter. Depending on the system setup, the real-time screen mayalso be shared by one or more transmit channels. Additional setup screens are provided for specialmodes that may be selected.3.1 PRIMARY RECEIVE SETUPAfter a receive mode selection (RCV), the following receive setup screen will appear.Channel: 1* RECEIVER SETUP *On/Off: : OFF Select Lbls: ALLBus Speed: 12.5 Equipment ID: 002> To step through options< To see Help screen for each line^ v To move to next/previous lineD To edit defaultsPress ENT to continue or anyfunction key to change functionsEach setup parameter will initially contain its default value unless changed by a previous setupsession. Before the operator can proceed to the real-time data display screen, a receive channelmust be enabled by setting On/Off to ON. If the user does not wish to change the other defaultsettings, the ENT key may be pressed to continue to the data display (real-time) screen.At any time while in the setup screens, pressing the CLR key will reset all the parameters to theirdefault values. The unit will ask for a confirmation (the C key confirms the action) before continuingwith the reset.Another function of the CLR key is to return to the Main Menu screen. This permits accessing thesystem setup recall function (since there is no dedicated key for this function). After pressing theCLR key, the unit will ask for a confirmation. Pressing F at this point will cancel the initialization andreturn to the Main Menu.DATATRAC 400 – REV 0 – PAGE 3-1