Datatrac 400 Operations Manual - Aeroflex

Safety and Regulatory InformationReview this product and related documentation to familiarize yourself withsafety markings and instructions before you operate this equipment.WARNINGThe WARNING notice denotes a hazard. It calls attention to a procedure,practice, or the like, that, if not correctly performed or adhered to, could result inpersonal injury. Do not proceed beyond a WARNING notice until the indicatedconditions are fully understood and met.CAUTIONThe CAUTION notice denotes a hazard. It calls attention to an operatingprocedure, practice, or the like, which, if not correctly performed or adhered to,could result in damage to the product or loss of important data. Do not proceedbeyond a CAUTION notice until the indicated conditions are fully understood andmet.Caution (refer to accompanying documents). Attention – refer to the manual.This symbol indicates that information about usage of a feature is contained inthe manual.IMPORTANT!WARNINGThe mains (ac) fuse holder and the dc fuse holder are located on the Rear Panel.An accessory kit of fuses and fuse carriers (caps) is provided, see item ACC4.For international requirements for JPN 01-1403-00 and 01-1403-02 units thefollowing fuses must be used: Install an IEC style, 5 mm X 20 mm, 1.6 A, 250 V,Type F fuse (ACC4F3) into the ac fuse holder, A12XF2 (fuse A12F2), with theproper fuse carrier (ACC4MP2). Also install an IEC style, 5 mm X 20 mm, 1.6 A,250 V, Type F fuse (ACC4F3) into the dc fuse holder, A12XF1 (fuse A12F1), withthe proper fuse carrier (ACC4MP2).For the USA: Install a ¼ X 1 ¼ inch, 1.5 A, 250 V, slow-blow fuse (ACC4F2) intothe ac fuse holder, A12XF2 (fuse A12F2), with the proper fuse carrier(ACC4MP1). Also install a ¼ X 1 ¼ inch, 1.5 A, 250 V, fast-blow fuse (ACC4F1)into the dc fuse holder, A12XF1 (fuse A12F1), with the proper fuse carrier(ACC4MP1).For all other markets check with the proper authorities for which of these kinds offuses to use.