RTCU-MX2i eco+ - Logic IO

RTCU-MX2i eco+Remote Telemetry and Control UnitTechnical DataPower supplyMin Typ MaxOperating Voltage8-36VDCProtected against wrong polarity.On-board Li-Ion Battery Pack1.8AhUnit ActiveUnit Active with GSM OnUnit Active with GPS OnUnit Active with GSM/GPS OnUnit Active while ChargingUnit in Power-downUnit in ”Wait for Event”Unit in ”Wait for Event”Unit in ”Wait for Event”, GSM On455065756500.40.4715mAmAmAmAmAmAmAmAmAGSM idle @ -63 dBmGSM idle @ -63 dBmRestart on: DI 5 and RTCResume on: DI, Vibration, RTCResume on: RS232Resume on: GSMTypical measurements @ 12 VDC Supply.MinTypMaxDigital inputsLogic ”High”Logic ”Low”8-512-403VDCVDCAll inputs are protected against transientsand low-pass filtered.MinMaxDigital outputs (Solid state)----361.5VDCAProtected against: Short circuit, ESD andinductive (Relay) kickback up to 20mH.MinMaxAnalog inputs0-+10VDCResolution is 10 bits. All inputs are protectedagainst transients and low-pass filtered.Storage temperature:Operating temperature(According to GSM 11.10 specification)Restricted operation(deviations from the GSM specification may occur)Charging Temperature(Low temperature charging available)Humidity (non condensing)-30-25-3005-----+65+55+65+4590ºCºCºCºC%External interfaces:• TYCO ”Mate’n’Lock’ connector for: RS232 port 1 (service port) Power, Digital I/O, Analog Input RS485, 1-wire• Three bi-color LED and one yellow status LED• SMA-Female connector for GSM antenna• SMB-Male for active 3 Volt GPS antenna• Standard 3 Volt SIM-Card reader (external access)Weight0.300KgAll interfaces are externally accessibleExternal dimensionsIngress Protection (IP)ApprovalsTechnical data subject to changeW 97 x H 35 x D 132 mmIP40 (SIM/Connectors in use)EN-61000-6-3;2001 EmissionEN-61000-6-2;2001 Immunitywithout SMA and SMB connectorsAluminum enclosure with10R-024899 034899Version UK 1.20For more information:Web: www.logicio.comEmail: info@logicio.comLogic IO, Holmboes Allé 14, DK-8700 Horsens, Denmark, Tel: (+45) 7625 0210, Fax: (+45) 7625 0211Page 4/4