Unifire Force 80 APWCS Installation Manual.pdf - PirateSafe.com

More documents

Recommendations

Info

System overviewMCU - Monitor Control UnitMCU bottom with cabel entries andmulticonnectorsJoystick with control cable by CCTVvideo monitorFORCE 80 with smoothbore nozzleand multiconnectorsJoystick connection boxes10
Force 80 ChassisGeneral Information & WarningsBE SURE TO USE THE PROPER TYPE AND SIZE OF THREADS AT THE MONITORBASE and also between the monitor and nozzle (if using a nozzle not supplied byUnifire specifically for use with this monitor). Use of the wrong type or size of threadswill result in an improper connection which can cause leaking and also may cause themonitor and/or nozzle to dislodge under high pressure, possibly leading to seriousinjury or death to persons and/or serious damage to property. If you have any doubtsas to the exact thread supplied by Unifire, contact Unifire for clarification prior toconnecting the monitor and nozzle.THE FORCE80 IS HEAVY. EXERCISE CAUTION AND SEEK ASSISTANCE WHENINSTALLING AND TAKE CARE TO AVOID INJURY TO YOUR BACK. Seekassistance to help support and twist the monitor during installation and take care toavoid injury to your back during handling and installation.BE SURE THAT THE MONITOR IS TIGHTLY AND PROPERLY SECURED AT ALLTIMES DURING OPERATION! Serious injury or death can occur if the monitor is notfully and properly secured and supported. Be sure that the mounting pipe for theForce 80 monitor is capable of withstanding a nozzle reaction force of at leasttwenty thousand (20,000) Newtons (2040 kgf). The Force 80 monitor should notbe used on a portable stand of any kind, as such use can be extremely dangerous andcan result in Serious Injury or Death.ONLY MOUNT THE FORCE MONITOR SO THAT ITS BASE IS PERPENDICULARTO THE GROUND. DO NOT install the monitor at an angle or upside-down withoutthe specific prior written consent of Unifire AB. Doing so voids the chassis warrantyand may cause damage to the monitor gears and motors, which could lead tomalfunction.BE SURE THAT THE MONITOR IS TIGHTLY AND PROPERLYSECURED AT ALL TIMES DURING OPERATION!Serious injury or death can occur if the monitor is not fully and properlysecured and supported. Be sure that the mounting pipe for the Force 80monitor is capable of withstanding a nozzle reaction force of at leasttwenty thousand (20,000) Newtons (2040 kgf). The Force 80monitor should not be used on a portable stand of any kind, as such usecan be extremely dangerous and can result in Serious Injury or Death.11
Page 4 and 5: PRODUCT WARNINGSIMPORTANT PRODUCT S
Page 6 and 7: ONLY USE THE MANUAL OVERRIDE IN CAS
Page 8 and 9: ITEM NAME & IMAGE PART # BRIEF DESC
Page 12 and 13: Piping overview• Pipe Ø 88,9mm
Page 14 and 15: Joystick “PI”The following is a
Page 16 and 17: 55005250500047504500425040003750350
Page 18 and 19: OPERATION - At first start up.Setti
Page 20 and 21: MAINTENANCEWe recommend that the el
Page 22 and 23: 4. MONITOR NOT RESPONDING• First
Page 29 and 30: APPENDIX 1MCU Industrial Cabinet Co
Page 31 and 32: APPENDIX 3Canbus JOYSTICK Descripti
Page 33 and 34: Calibration of nozzle control. (III
Page 35: APPENDIX 5Outline DrawingFitting in

Unifire Force 80 APWCS Installation Manual.pdf - PirateSafe.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?