Thermal Shock Chambers - MB Electronique

InstrumentationColor LCD interactive touch-screen systemOperation and settings simplified by theuse of a touch-screen LCD display(instructions displayed on-screen). At-aglanceconfirmation of test patterns, testarea temperatures, temperature cycles,upstream / downstream control, and trendgraphs display.●Test settings●Test detail monitorEnhanced test halt preset function(Patent pending)It is now possible to program tests to haltafter cycle or exposure completion. Sixcycle counters are also built-in to theinstrumentation so a test halt preset canbe programmed for each counter. Thefunction can be used to multiple ends suchas removing specimens to the chamber.Test continuity selection functionWhen the test is halted, select to resumethe test from the point where it was haltedor to start the test from the beginning.SettingInteractive key input by touch panelDisplayTFT Color LCD (10.4–inch)● Halt preset function● Service guideTemperaturecontrolfunctionTest area: exposure temp.Hot chamber: pre-heating temp.Cold chamber: pre-cooling/defrosting temp.Temperature controls are PID controlSettingresolutionTemperature: 1°CTime: 1 min.(Remaining time display is 1 sec.)InputThermocouple type T (copper/copper-nickel)Setting rangeTime: 0 to 99 hours 59 minutesTest cycle: 1 to 9999 cycles7● AlarmTest patternsAuxiliaryfunctionsRAM (freely register): 40 patterns max.(Registration possible)ROM (built-in fixed): 20 standard test patternsRegistered• Timer preset • Program memory• Test continuity selection • Automatic power• Overheat/overcoolshut-offprotection• Programmed time• Up-stream/down-streamdisplaysensor selection • Cycle counter• Stable time control • Test halt preset• Exposure time reduction • Completion mode• Eco operationselection• Power failure recovery• Trend graphoperation selection • Alarm history display• Automatic defrost • Sensor calibration• Temperature recovery • RS–485 communicationtime setting• Accumulated time• Pre-conditioning/posttreatment• Dry operation