Prisma Plus G - Schneider Electric

00604010060401000604010006040100Functional systemFunctional unitsand distributionOther devicesHuman-switchboard interface2 types of device mounting72x72 and 96x963 mounting types inPrisma Plus System GDd3817051 1> On an interface with plastic mountingplates clipped onto the metal front platewith cut-outs> In the device zone of wall-mounted andfloor-standing enclosuresDd381685AAAAbbThe interface is made up of a metal front plate andplastic mounting plates that clip onto the front plate.bbThe devices are attached in the cut-outs ofthe plastic mounting plates and insulated fromthe front plate.Dd3816872> On a partial door with cut-outs in wallmountedand floor-standing enclosuresbbA system at the rear of the mounting platesguides the wires.bbEach mounting plate can receive an adhesive label.bbPlain mounting plates are available to blank off anyunused locations.2> Directly on a metal front platewith cut-outsbbWith flexible trunking to protect and guidewiring to door (04235).3> On a partial door with cut-outs,on an inclined visor by 30 °Dd381689Dd382636Dd381688Dd382574Dd381643bbDevices are attached directly to the metalfront plate.bbBlanking plates are available to blank offany unused locations.bbWith cut-out plastic mounting plate directlyclipped on the visor.bbSupplied with a drilling diagram for mountingon a plain door.Note:- to maintain the IP55 degree of protection, the measurement devices must be installed behind a transparent door.- if they are installed on a plain door, use the corresponding mounting plates. ( > see page 53).52