QUICK INSTALLATION INSTRUCTIONS FOR PROGRAMMING ...

More documents

Recommendations

Info

5. This is the start of the automatic programming procedure:Run Start -> Programs->Sidexis->Configuration of X-Ray components.6. Click on the Attributes TAB and Click new component. Follow the instructions.pg. 2Sirona Dental Systems LLC 4835 Sirona Drive Suite 100 Tel: 1 800 659 5977 ext 101 Fax: (704) 587 9394
7. Switch on ONE X-ray com ponent and you’ll see suggested the next free address, probably192.168.15.100 ( this might take up to two minutes).Click OK at the dialog ( “… to apply these addresses press apply… ..)Done 8. Double check the suggested addresses. Done If this address is not desired, put in the address and subnet mask and default gatewaythe administrator gave to you.(suggested x.x.x.10x for intraoral boxes, x.x.x 200 or x.x.x.240 for Orthophos or Galileos units)Hit apply, and have the system run the test.Done 9. Do not skip the step where you should switch off the x-ray device. Observe 1 min down-timefor Orthophos or Galileos units.OK 10. Change the name of the device to the one you want to use, Hit Apply. Done 11. Repeat steps 6 to 8 with all existing x-ray components. OK 12. In the bottom window of the Attributes Tab check the computer(s) you want to be able to use the selectedXray device with. (Shown in the top name field). If you have more than one x-ray device,select one after the other and check-box for the appropriate computers.(Usually only one X-Ray device will be used with one computer.Done (I.E.: X-R ay box1 w ith com puter “operatory1”. ).13. Switch to the Sensor Tab and install all sensor disks if you have intraoral sensors. Any sensor hasto be installed only once to work all over the network.Done 14. T hat’s it.pg. 3Sirona Dental Systems LLC 4835 Sirona Drive Suite 100 Tel: 1 800 659 5977 ext 101 Fax: (704) 587 9394
Page 1: product.service@sirona.comJanuary 0

QUICK INSTALLATION INSTRUCTIONS FOR PROGRAMMING ...

Create successful ePaper yourself

Delete template?

Save as template?