Operation Manual - Home Mega Global Solution

ELECTRICAL TRIPThis LED indicates that an electrical trip alarm has occurred. The exact nature of the electrical tripwill be displayed on the LCD display. For further details refer to the ‘Protections’ section of thismanual.FAULT SHUTDOWNThis LED indicates that a shutdown alarm has occurred. The exact nature of the shutdown will bedisplayed on the LCD display. For further details refer to the ‘Protections’ section of this manual.FAIL TO STARTThis LED indicates that the module has attempted to start the engine. Once all attempts to starthave been made without success this LED will illuminate. For further details refer to the ‘Protections’section of this manual.LOW OIL PRESSUREThis LED indicates that a low oil pressure alarm has occurred. The exact nature of the warning willbe displayed on the LCD display. For further details refer to the ‘Protections’ section of this manual.HIGH ENGINE TEMPERATUREThis LED indicates that a high engine temperature alarm has occurred. The exact nature of thewarning will be displayed on the LCD display. For further details refer to the ‘Protections’ section ofthis manual.UNDER/OVERSPEEDThis LED indicates that an underspeed or overspeed alarm has occurred. The exact nature of thewarning will be displayed on the LCD display. For further details refer to the ‘Protections’ section ofthis manual.GEN. UNDER/OVER VOLTSThis LED indicates that a generator under voltage or over voltage alarm has occurred. The exactnature of the warning will be displayed on the LCD display. For further details refer to the‘Protections’ section of this manual.EMERGENCY STOPThis LED indicates that an emergency stop alarm has occurred. The exact nature of the warning willbe displayed on the LCD display. For further details refer to the ‘Protections’ section of this manual.STOP/RESETThis LED indicates that the module is operating in ‘Stop/Reset’ mode. For further details refer to the‘PUSH-BUTTONS’ section later in this manual.MANUALThis LED indicates that the module is operating in ‘Manual’ mode. For further details refer to the‘PUSH-BUTTONS’ section later in this manual.STARTThis LED indicates that the module is receiving a start pushbutton command. For further details referto the ‘PUSH-BUTTONS’ section later in this manual.AUTOThis LED indicates that the module is operating in ‘Stop/Reset’ mode. For further details refer to the‘PUSH-BUTTONS’ section later in this manual.TESTThis LED indicates that the module is operating in ‘Test’ mode. For further details refer to the ‘PUSH-BUTTONS’ section later in this manual.ALARM MUTE14606 OPERATING MANUAL ISSUE 2 11/27/00 MR