Composite mold resurfacing - Hawkeye Industries

More documents

Recommendations

Info

Spraying the topcoatApply a "tack coat" to theentire surface and allow itto flash for 2 minutes.Follow with a mist coat andtwo-three wet passes toachieve a thickness of 15-20 mils, 375-500 microns,over the sanded surface.
Curing the topcoatAllow the topcoat to cure to a“dry-to-the-touch” condition(4-8 hours at 77°F, 25°C).If properly applied there willbe very little orange peel ordry overspray.The topcoat must be sandedand polished to achieve fullcure and best performance.
Page 1 and 2: COMPOSITE MOLD RESURFACINGWITH DURA
Page 3 and 4: Repair vs. Resurfacing Chips, crack
Page 5 and 6: Prepping the MoldThe surface should
Page 7 and 8: Prepping the moldWipe thesandedsurf
Page 9 and 10: Product preparationCatalyze at 2 pe
Page 11 and 12: Spraying the moldFollow with wet pa
Page 13 and 14: Allowing the mold to dryThe primer
Page 15 and 16: Cleaning the moldWipe the surface w
Page 17 and 18: Product PreparationThoroughly stir
Page 19: Spraying the topcoatWe recommend a
Page 23 and 24: Compounding the moldRemove scratche
Page 25 and 26: Compounding the moldUsing a profess
Page 27 and 28: Compounding the moldBuff the surfac
Page 29 and 30: Polishing the moldApplication—App
Page 31 and 32: Polishing the moldWhile polishing,
Page 33 and 34: Polishing the moldPolish until the

Composite mold resurfacing - Hawkeye Industries

Create successful ePaper yourself

Delete template?

Save as template?