Composite mold resurfacing - Hawkeye Industries

More documents

Recommendations

Info

Duratec® and Aqua-Buff ® Productsfor Polyester and VE Mold ResurfacingDuratec Vinyl Ester Mold RepairPutty (if needed)Duratec Polyester SurfacingPrimerDuratec Vinyl Ester Hi-GlossTopcoatDuratec ThinnerAqua-Buff Tuff-Stuff® Rapid CutCompoundAqua-Buff GlossMaster® Polish
Prepping the MoldThe surface should be clean, dry and free from oil,grease, wax or other contaminants.Ambient temperatures should be in excess of 60°F,16°C to ensure a rapid and complete cure.Time calculations are based on temperatures of77°F, 25°C.Prior to sanding the surface all <strong>mold</strong> releases mustbe removed using the chemical stripperrecommended by the <strong>mold</strong> release manufacturer.
Page 1 and 2: COMPOSITE MOLD RESURFACINGWITH DURA
Page 3: Repair vs. Resurfacing Chips, crack
Page 7 and 8: Prepping the moldWipe thesandedsurf
Page 9 and 10: Product preparationCatalyze at 2 pe
Page 11 and 12: Spraying the moldFollow with wet pa
Page 13 and 14: Allowing the mold to dryThe primer
Page 15 and 16: Cleaning the moldWipe the surface w
Page 17 and 18: Product PreparationThoroughly stir
Page 19 and 20: Spraying the topcoatWe recommend a
Page 21 and 22: Curing the topcoatAllow the topcoat
Page 23 and 24: Compounding the moldRemove scratche
Page 25 and 26: Compounding the moldUsing a profess
Page 27 and 28: Compounding the moldBuff the surfac
Page 29 and 30: Polishing the moldApplication—App
Page 31 and 32: Polishing the moldWhile polishing,
Page 33 and 34: Polishing the moldPolish until the

Composite mold resurfacing - Hawkeye Industries

Create successful ePaper yourself

Delete template?

Save as template?