Composite mold resurfacing - Hawkeye Industries

More documents

Recommendations

Info

Sanding the topcoatWhen the topcoat has cured,begin with the finestsandpaper that will takedown the surface profile andsand the surface, workingthrough the grits, up to 1000-grit paper.Note: For best results, after sanding, wait atleast overnight at 77°F, 25°C beforecompounding and polishing the surface. Forexceptionally large <strong>mold</strong>s that require twodays or more days of sanding, no waiting isnecessary.
Compounding the <strong>mold</strong>Remove scratcheswith Aqua-BuffTuff-Stuff RapidCut Compound.We recommendan industrialstyle buffer,operating at2200 rpm.
Page 1 and 2: COMPOSITE MOLD RESURFACINGWITH DURA
Page 3 and 4: Repair vs. Resurfacing Chips, crack
Page 5 and 6: Prepping the MoldThe surface should
Page 7 and 8: Prepping the moldWipe thesandedsurf
Page 9 and 10: Product preparationCatalyze at 2 pe
Page 11 and 12: Spraying the moldFollow with wet pa
Page 13 and 14: Allowing the mold to dryThe primer
Page 15 and 16: Cleaning the moldWipe the surface w
Page 17 and 18: Product PreparationThoroughly stir
Page 19 and 20: Spraying the topcoatWe recommend a
Page 21: Curing the topcoatAllow the topcoat
Page 25 and 26: Compounding the moldUsing a profess
Page 27 and 28: Compounding the moldBuff the surfac
Page 29 and 30: Polishing the moldApplication—App
Page 31 and 32: Polishing the moldWhile polishing,
Page 33 and 34: Polishing the moldPolish until the

Composite mold resurfacing - Hawkeye Industries

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?