Composite mold resurfacing - Hawkeye Industries

More documents

Recommendations

Info

Product preparationThoroughly stir Duratec Polyester SurfacingPrimer prior to catalyzing.Due to the rapid gel time of the primer,mix only the amount that can be appliedwithin 16-18 minutes @77°F, 25°C.(Higher temperatures yield a shorter potlife and gel time, while lower temperaturesyield a longer pot life and gel time.)
Product preparationCatalyze at 2 percent withmekP catalyst (20 cc per quart).The primer can be thinned up to10 percent if necessary toachieve a fine spray. Thin withDuratec Thinner or Methyl EthylKetone solvent aftercatalyzation.
Page 1 and 2: COMPOSITE MOLD RESURFACINGWITH DURA
Page 3 and 4: Repair vs. Resurfacing Chips, crack
Page 5 and 6: Prepping the MoldThe surface should
Page 7: Prepping the moldWipe thesandedsurf
Page 11 and 12: Spraying the moldFollow with wet pa
Page 13 and 14: Allowing the mold to dryThe primer
Page 15 and 16: Cleaning the moldWipe the surface w
Page 17 and 18: Product PreparationThoroughly stir
Page 19 and 20: Spraying the topcoatWe recommend a
Page 21 and 22: Curing the topcoatAllow the topcoat
Page 23 and 24: Compounding the moldRemove scratche
Page 25 and 26: Compounding the moldUsing a profess
Page 27 and 28: Compounding the moldBuff the surfac
Page 29 and 30: Polishing the moldApplication—App
Page 31 and 32: Polishing the moldWhile polishing,
Page 33 and 34: Polishing the moldPolish until the

Composite mold resurfacing - Hawkeye Industries

Create successful ePaper yourself

Delete template?

Save as template?