TK 442/3

More documents

Recommendations

Info

24 5 Axis machining centres OptionalTK 442/3Barcode readerThis device reads the labels applied on profiles and allows the system to automatically load the machining program and thetransfer of some parameters of use. The reader is also available in “wireless” release.Remote controlled electronic wheelIt moves the axis and performs milling operations activated by manual commands, allowing the operator to walk along themachine. Thanks to the electronic wheel it is also possible to start and run the machining program without going back to thecommand console.Voltage stabilizerIt stabilizes the machine voltage supply, even if some voltage losses occur.Uninterruptible power supply (UPS)The UPS is a device which maintains a continuous supply of electric power when utility power is not available.In case of a blackout, while the machine enters emergency mode, the CNC does not stop (because it is powered by the UPS)thus allowing the operator to save manually or with an automatic routine the already performed job.
Software5 Axis machining centresTK 442/325HardwareThe CN6 hardware is made up by two processors: A processor controls the CN6 and the other controls the functionsof a common PC; thanks to this system you can use the function of the common PC even while the machining center isworking.It includes:CPU PENTIUM cardKeyboard, mouse, LCD 17’’ color screenEthernet card for the network connectionUSB and parallel portsAxis and spindle speed control cardsHard Disk with minimum capacity of 40 GbModem for the direct connection via Internet
Page 1 and 2: Technical SpecificationTK 442/35 Ax
Page 3 and 4: 5 Axis machining centresTK 442/3TEK
Page 5 and 6: 5 Axis machining centresTK 442/3
Page 7 and 8: 5 Axis machining centresTK 442/3350
Page 9 and 10: 5 Axis machining centresTK 442/3Mac
Page 11 and 12: 5 Axis machining centres11TK 442/3M
Page 13 and 14: 5 Axis machining centres13TK 442/3L
Page 15 and 16: 5 Axis machining centres15TK 442/3M
Page 17 and 18: 5 Axis machining centres17TK 442/3F
Page 19 and 20: 5 Axis machining centres19TK 442/3T
Page 21 and 22: Optional5 Axis machining centresTK
Page 23: Optional5 Axis machining centresTK
Page 27 and 28: Software5 Axis machining centresTK
Page 29 and 30: Software5 Axis machining centresTK
Page 31 and 32: Optional software5 Axis machining c

TK 442/3

Create successful ePaper yourself

Delete template?

Save as template?