Weatronic internal gyro programming 1 This article describes how ...

Now drag the right end point of the curve down to the zero vertical value.Now add in one more point towards the right end and drag it down to zero gain so that itmatches the left side. The curve of the gain should be symmetrical.Next, change your Tx program to send aileron control without trim to the gain channel andremove the slider control from the gain channel. You want the aileron channel without trimso that trim does not affect the gain position, and also without any altered centre point, subtrimsetc. If your Tx software does not allow you to send the stick position without trims etc,we can accommodate this with a slight variation in GigaControl later. The aileron stick will