Introduction

More documents

Recommendations

Info

1/23/2011Double ended input, unbalance output.Single ended input, balance output10
1/23/2011Single ended input, unbalance output.DEFFERENTIATE THE CONFIGURATIONEach configuration is categories based on several factors:1. Input signal quantity that use in circuit connection; Input : 2 input signal is used, so it is called 2 input Input: 1 input signal is used, so it is called single input.2. How output voltage being measured. If the voltage is measured between 2 collectors, the output will bebalance. If the voltage is measured at a collector and refer to ground, the outputwill not balance.2211
Page 4: Neue Presse, Kronach
Page 12 and 13: 1/23/2011OP AMP INTERNAL BLOCK DIAG
Page 14 and 15: 1/23/2011High Gain Voltage Amplifie
Page 16 and 17: 1/23/2011Consist of 4 cascade ampli
Page 18 and 19: 1/23/2011Open Loop Gain(A OL )• A
Page 20 and 21: 1/23/2011Offset CurrentCaused by di
Page 22 and 23: 1/23/2011Comparison of Operational
Page 24 and 25: 1/23/2011INTRODUCTIONTimer 555 is v
Page 26 and 27: 1/23/2011Pin 4 : ResetUsed to reset
Page 28 and 29: 1/23/2011MONOSTABIL MULTIVIBRATORMO
Page 30 and 31: 1/23/2011At the same time, the outp
Page 32 and 33: 1/23/2011 This situation can be obs
Page 34 and 35: 1/23/2011ASTABLE MULTIVIBRATORExamp
Page 36: 1/23/2011a) State the functions of

Introduction

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?