TANK TEMPERATURE CONTROLLER - GW Kent

status, heat,HSCCoolinghysteresis0.1… 20 after0.11 Cooling hysteresis,temperature range within which thecooling output: does not change itsstatus, cool.dbd Dead zone 0.1… 20 after0.1dead zone, temperature rangesymmetrically around t[e set valuePV, within which neither the coolingoutput not the heating outputchange their status.ALUHigh temperatureAlarm Point-9.9”99.9°CAfter 0.199.9˚Chigh temperature value indicatorlight would be flashed when PVtemperature is over the ALU value.ALdLow temperatureAlarm Point.-9.9”.’99.9°CAfter 0.114-211°FAfter 0.l-9.9°Clower temperature value indicatorlight would be flashed when PVtemperature is under ALU value.4.3 Third ParametersTo set the Third Parameters- press and hold the [SET] button. When ‘PAS’ (password) is displayed- use the arrow keys to enter: [▲▲▼▼▼]- confirmed by pressing button [SET]. The display will then show the first parameter- select the desired parameter by pressing ▲▼- and confirm by pressing [SET] button- this will show the set value- to change the value press ▲▼- confirm by pressing [SET] button.Parameters are:Abv. Parameter Range Default Description