(pm halo) helmet assembly - Gentex Corporation

8. Inspect the bayonet receivers as follows:CAUTIONDo not use thread-locking adhesive on the bayonet receiver screws.The spacers will be damaged if they come into contact withthread-locking adhesive.a. Inspect the spacers for cracks or deterioration.b. Ensure that the screws are securely tightened and that the lock washersare installed.c. Ensure that the receivers were installed with the part number facing thehelmet shell.9. Inspect the helmet visor snaps as follows:a. Inspect the snap screws for corrosion and tightness. Assure that thehelmet is thoroughly cleaned and serviceable before returning to user.b. Check the snaps for security and proper installation of lock washer, partnumber MS35335–58.CLEANING1. Helmet Shell. Clean the helmet shell as follows:a. Wash the helmet shell using a mild detergent and a lint-free clothdampened with water. Mild abrasive scouring powder or soft-scrubbingcleanser may be used to remove stains or scuff marks.b. Wipe the helmet shell clean using a water-dampened cloth toremove detergents.2. Nape Strap Assembly. Clean the nape strap assembly as follows:a. Lightly sponge with a mild solution of detergent and water.b. Wipe with a damp, lint-free cloth.3. Adjustable Pad Suspension. Clean the adjustable pad suspension asfollows:a. Remove the pads from the helmet.b. Remove the foam pads from the covers.c. Hand wash the covers and foam pads and allow them to air dry.d. Reinstall the foam pads into the covers.e. Reinstall the adjustable pad suspension system into the helmet.f. Don the helmet and check the fit as described on Pages 7 and 8.(Continued on next page)24