Radiation board - Libelium

More documents

Recommendations

Info

Waspmote Plug & Sense!2.8. Meshlium Storage Options• Local Data Base• External Data Base2.9. Meshlium Connection Options• ZigBee → Ethernet• ZigBee → Wifi• ZigBee → 3G/GPRS-10- v4.1
Waspmote Plug & Sense!2.10. ModelsThere are some defined configurations of Waspmote Plug & Sense! depending on which sensors are going to be used. WaspmotePlug & Sense! configurations allows connecting up to six sensor probes at the same time.Each model takes a different conditioning circuit to enable the sensor integration. For this reason each model allows to connectjust its specific sensors.This section describes each model configuration in detail, showing the sensors which can be used in each case and how toconnect them to Waspmote. In many cases, the sensor sockets accept the connection of more than one sensor probe. See thecompatibility table for each model configuration to choose the best probe combination for the application.It is very important to remark that each socket is designed only for one specific sensor, so they are not interchangeable.Always be sure you connected probes in the right socket, otherwise they can be damaged.ABCDEFFigure 9: Identification of sensor sockets-11- v4.1
Page 1 and 2: Radiation boardTechnical Guidewaspm
Page 4: General1. General1.1. General and s
Page 7 and 8: Waspmote Plug & Sense!Figure 4: Was
Page 9: Waspmote Plug & Sense!2.6. Program
Page 13 and 14: Hardware3. Hardware3.1. General des
Page 15 and 16: Hardware3.3. Electrical characteris
Page 17 and 18: Sensors4. Sensors4.1. Radiation sen
Page 19 and 20: SensorsMoreover, the Geiger-Müller
Page 21 and 22: Board configuration and programming
Page 23 and 24: Board configuration and programming
Page 25 and 26: Documentation changelog7. Documenta
Page 27: Disposal and recycling9. Disposal a

Radiation board - Libelium

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?