Radiation board - Libelium

More documents

Recommendations

Info

Hardware3.2. SpecificationsWeight: 50grDimensions: 92 x 60 x 1.3 mmTemperature Range: [-20ºC, 65ºC]Electronic components used in the radiation board can be divided in next parts:1. High voltage power supplyHigh voltage power supply uses a circuit based on an oscillator connected to a voltage multiplier made with diodes,transistors, resistors and capacitors (see schematic for detail).2. Adaptation circuit for the Geiger outputThe adaptation circuit for the output is based on a NPN transistor, this transistor will trigger the interrupt pin in theWaspmote microcontroller which make the interrupt routine associated to be executed, adding one to the current counter.Even this transistor is also activating/deactivating the piezo speaker and LED indicator generating the audio/visual signal.3. Piezo speaker and LED indicatorThe piezo speaker and LED indicator are connected to the adaptation circuit, so LED will blink with each pulse and speakerwill sound with each pulse.4. LED barLED bar is made with five standard LEDs, 3 green and 2 red. These leds are connected to digital pins of the microconrollerwith a series resistor. LED bar can be configured in order to give a visual information of the measured radioactivity level.Default configuration (loaded in the Waspmote API example) is predefined for next threshold values in cpm units.Radiation value (cpm)LED barValue < 75OFF75 < Value < 150 1 Green LED150 < Value < 400 2 Green LED400 < Value < 600 3 Green LED600 < Value < 900 3 Green LED, 1 Red LEDValue > 9003 Green LED, 2 Red LEDIn addition, LED bar can be handled by changing state of corresponding Waspmote pin, using functions likedigitalWrite(pin,state), defined into Waspmote API. Digital pin numbers are described during this guide.All described parts and their board location are shown in next figure.Figure 11: Parts of the radiation board-14- v4.1
Hardware3.3. Electrical characteristicsBoard power voltages: 5V / 3V3Geiger-Müller tube power voltage: 370VMaximum admitted current (continuous): 200mAMaximum admitted current (peak): 300mASpeaker: 95dB, 3.4KHzExternal ON/OFF switch.LED bar with 5 leds (3 green and 2 red).Next figure shows schematic of radiation board.-15- v4.1
Page 1 and 2: Radiation boardTechnical Guidewaspm
Page 4: General1. General1.1. General and s
Page 7 and 8: Waspmote Plug & Sense!Figure 4: Was
Page 9 and 10: Waspmote Plug & Sense!2.6. Program
Page 11 and 12: Waspmote Plug & Sense!2.10. ModelsT
Page 13: Hardware3. Hardware3.1. General des
Page 17 and 18: Sensors4. Sensors4.1. Radiation sen
Page 19 and 20: SensorsMoreover, the Geiger-Müller
Page 21 and 22: Board configuration and programming
Page 23 and 24: Board configuration and programming
Page 25 and 26: Documentation changelog7. Documenta
Page 27: Disposal and recycling9. Disposal a

Radiation board - Libelium

Create successful ePaper yourself

Delete template?

Save as template?