Cyclone Electric Start Kit - Vintage Snow

INSTALL TAIL BRACKET ON STARTER MOTORAND PREPARE BA'I"I'ERY FOR INSTALLATIONAf ter bat tery i s properly charged.add el ect rolyte unt i l level wi t h circular split l edge in fil ler t ube. Thereafter.add only distil l ed water to batteryas us e and t ime require .A'ITACH STARTER MOTOR TOENGINE1 . Attach tail bracket to starter motorwith a 1/4" x 3/4" thread cuttings crew.NOTE: Turn thread cutt ing screwal-l- the way into starter motor hole andthen back it out two or three turns.Leave the tail bracket loose until afterstarter motor is installed.2. Obtain a J ohn Deere battery (partno. AH52050) from stock. Sl i p over f l owtube over nipple on battery as shownabove.Remove ba t tery cell caps and addelectrolyte t o battery as explainedbe low.CAUTION: Battery eleot aolv te ispoi sonous and can be injurious toeyes, skin and olothing. Be carefULwhen adding eleotrolqte t o bat t ery .Use only battery grade sulfuricacid electrolyte with 1.265 s peci ficgravi ty pl us or minus 0.005 cor r e ctedto 80 degrees f ahrenheit.Use sp ecial pr ecaut i on when fillingthis small battery. Never place batteryin sno~bile before the electrolyte isadded. Pour in electrolyte slowlyuntil vi si bl e i n the bottom of eachf1lling tube . Then charge battery 15amps for 10 minutes or 7 amps for 30minutes. DO NOT EXCEED RECOMMENDEDCHARGING RATE.1 . Pl ace starter motor spacer overt he two stud bo l ts on engine hous ing.2. Insert drive gear end of startermotor into housing . Secur e s t art e rmotor to top stud bol t on housi ng withone 8 mm flange nut . Tighten nutsecurely.3. Bolt starter motor tail bracketto engine with two 5/16" lock washersand two 8 rom x 18 mm hex. socket headbolts. Tighten bolts securely.4. Tighten thread cut t i ng screw ontail bracket securely.- 3-