Cyclone Electric Start Kit - Vintage Snow

J-CLIP TOENGINE BOLT1 . Remove and save t he 6mm x 15 mm boltfrom r i ght-hand side of engine. BoltJ-~l ip to side of engi ne and fan shieldhousing with two 9/ 32" x 5/ 8" x .060" f latwashers and a 6 mm x 20 rom hex. headbolt.INSTALL BATTERY BOX ASSEMBLY,I3. Bolt r ear par t of battery boxmounting bracket to tunnel with two11/32" x 1" x . 060" flat washers. two5/16" x 3/4" hex. he ad bolts,and two5/16" lock nuts.Cut out paper template provided onpage 7. Cut out dashed line area ontemplate for locating and drillingholes in tunnel.1. Pla ce templ ate on tunnel as shownabove. Be sure template is flush withfront and right-hand edges of tunnel.2 . Us i ng a center punch and hammer,mark through the two . 344 holes ontemplate into tunnel . Remove templateand drill two 11/32" holes throughtl.alDel.NOTE: Aeeesdr l e fiat uaehere on boltsand i nsert bolts up from bottom oftunnel. Fla t washers must be beneathboZt heads to prevent the boZt headsf rom being pu Lled through the tunneL,4. Position front part of batterybox mounting bracket on tunnel as shownabove. Using holes in bracket as atemplate, drill two 11/32" holes throughtunnel. Bolt front battery box bracketto tunnel with two 11/32" x I" x .060"flat washers. two 5/16" x 3/4" he x. h eadbolts , and two 5/16" l ock nuts.,5. Place the two oattery box padsi n battery box as shown above.-4-