V454501 Single Preset Counter - Danaher Specialty Products

More documents

Recommendations

Info

P R O G R A M M I N GThe Operator Mode is used for viewing theCount value and viewing/changing thePreset value.Count valuePreset valueNOTETo abort an editoperation (before thenew value is confirmed),press the Down and Nextkeys together.Press the Next key to enter Edit Mode.The most significant digit of the PresetData display will then flash. Press theNext key repeatedly as required to selectthe desired digit.WARNING!Caution should beobserved if it isnecessary to changethe preset value whilethe process isoperating. Do not setvalues which arealready exceeded bythe count value withoutresetting the counter.Press the Down key to change the valueof the selected digit (there is wrap-roundfrom 0 to 9).When all digits are as required, press theENT key to confirm the changes; thedisplay will stop flashing.IMPORTANTYou must press the ENT key within 15seconds of the last keypress when entering anew value, otherwise the new value will bediscarded and the old value will be retained.
WARNING!Changing ProgramMode parameter valueswhile the process isoperating may behazardous to theoperator and/or thecontrolled equipment.Use extreme cautionand stop the processbefore attempting tochange Program Modeparameter values.IMPORTANTYou must press the ENTkey to implement newparameter values.To enter Program Mode, set the PGM input active (low) e.g. by tying it to COM.Whilst in Program Mode, the PGM indicator will be ON.FunctionPre-scalerOut TimeDecimal PointParameterDescription(Upper Display)MeaningPre-scales counter operation(multiply from 0.001 to 9.999)Value = Count units displayedCount pulses inputSets momentary ON time forPRESET output (0.01 - 99.99s;0.00 for latched operation)Defines decimal point positionNOTEPossible Decimal PointPosition settings are:Operator Mode:PresetNoneShows Preset valueNOTES1. To adjust Pre-scaler, Out Time or Preset value (as selected), press Nextkey to enter Edit Mode (digits will flash), use Next key to select each digit tobe adjusted, and adjust digit value using Down key. When adjustment iscomplete, press ENT key to exit Edit Mode (digits will become static).2. To adjust decimal point position, select that parameter, press Next key toenter Edit Mode, then use Next key to position decimal point. Press ENT keywhen finished.To exit Program Mode, set the PGM input inactive (High).
Page 1 and 2: IntroductionA new standard of perfo
Page 3 and 4: I N S T A L L A T I O NIMPORTANT: I
Page 5: O P E R A T I O N1. Upper Display2.
Page 9 and 10: A P P E N D I X AInput PowerAC:DC:P
Page 11 and 12: N O T E S11

V454501 Single Preset Counter - Danaher Specialty Products

Create successful ePaper yourself

Delete template?

Save as template?