Product Manual - Zemic

Recommendations

Info

9.0 Source MilliampsSelect Source mA in the main menu then press the enter key.9.1 Source mADisplay ( left or right keys to change)mA display onlyormA & Mass. (See 9.2)orMass & mA. (See 9.3)Range ( left or right keys to change)0-20mAor4-20mAFunction ( left or right keys to change)LinearorFloworValveMode ( left or right keys to change)IncrementorSteporAuto SteporRampMain Unit ( left or right keys to change)mAor%<strong>Zemic</strong> Europe info@zemic.nl www.zemic.nl18
Loop Power ( left or right keys to change)On (24V loop is active)orOff (Simulates mA)Press enter to source mAUse value set keys to change mA value thenpress enter to output new value (+ Steady)9.2 Source mA & MassDisplay ( left or right keys to change)mA. (See 9.1)ormA & Mass (to set mA value and displaymass)orMass & mA. (See 9.3)mA range ( left or right keys to change)0-20mAor4-20mADec Point ( left or right keys to change)Select required position for decimal pointO(4) mA value:Set to low scale value for 0 (or 4) mA<strong>Zemic</strong> Europe info@zemic.nl www.zemic.nl19
Page 1 and 2: Zemic Europe info@zemic.nl www.zemi
Page 3 and 4: Contents1.0 Introduction...32.0 Get
Page 5 and 6: 1.0 IntroductionCALOGThe - LC II is
Page 7 and 8: 2.3 SafetyYour calibrator is not su
Page 9 and 10: 4.0 Wiring SchematicsThis section s
Page 11 and 12: 4.4 Weighing System Pre-calibration
Page 13 and 14: 5.0 Test LoadcellSelect TEST LOADCE
Page 15 and 16: 7.2 Measure mVdc & Mass (and Measur
Page 17 and 18: 8.0 Weighing System Pre-calibration
Page 19: Span valueSet high value.(If 3 x 1
Page 23 and 24: Dec Point ( left or right keys to c
Page 25 and 26: Display SpanSet span valueUnit ( le
Page 27 and 28: Item: Use Left and Right keys to se
Page 29 and 30: Language ( left or right keys to ch
Page 31 and 32: 14.0 Maintenance14.1 Opening your C
Page 33 and 34: 15.0 Technical Specifications15.1 G
Page 35: Zemic Europe B.V. T: +31 76 50 39 4

Product Manual - Zemic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?