Chiltern A12138 .pdf - Falcon Panel Products

14 Additional & Alternative Hardware14.1 Latches & LocksLatches and locks must either be as tested, or alternatively components with thefollowing specification are acceptable:Maximum forend andstrike plate dimensionsMaximum bodydimensions235mm high by 25mm wide by 4mm thick18mm thick by 100mm wide by 165mm highIntumescent protection See section 11MaterialsPositionAll parts essential to the locking/latching action (includingthe latch bolt, forend and strike) to be steel or stainlesssteel1000mm to 1200mm from the threshold14.2 HingesDoor leaves must be hung on a minimum of 3 hinges. Leaves over 2135mm highmust fit 4 hinges. Leaves over 2700mm high must fit 5 hinges. Hinges with thefollowing specification are acceptable:ElementBlade heightBlade width(excluding knuckle)Blade thicknessFixingsMaterialsHingepositionIntumescentprotectionLeafdimension2135mm90 – 120mm30 – 35mm2.5 – 4mmSpecificationMinimum of 4 No. 30mm long No. 8 or No.10 coarselythreaded wood type, steel screws per bladeSteel or stainless steelTop 6 150 6180mm from the head of leaf to topof the hinge2 nd 6 Minimum 200mm from top hinge orequispaced between top and bottomhingesBottom 6 180 – 250mm from the foot of the leaf tobottom of the hingeTop 6 1506180mm from the head of leaf to topof the hinge2 nd & 3 rd 6 2 nd hinge minimum 200mm from top(leaves 2700mm)hinge6 Equispaced between top and bottomhingesBottom 6 180 – 250mm from the foot of leaf tobottom of the hingeSee section 11The legal validity of this report can only be claimed on presentation of the complete report.Report for: Falcon Panel Products Ltd.Ref: Chilt/A12138 Page 21 of 47