Rialta Service Manual - RialtaInfo

SECTION 1ELECTRICALGENERATOR REMOVAL1. Place ignition key in OFF position.2. Disconnect negative lead from chassis battery.3. Disconnect tailpipe. from generator muffler.4. Disconnect battery cable from generator.5. Disconnect 12-volt control wiring connector at generator.6. Disconnect fuel line from filter at generator.7. Remove the junction box cover from junction box containing generator output wiring (located underthe left dinette seat). Note the location of connections for ease of later installation. Remove wire nutsfrom ground wire, neutral wire, and hot wire. Loosen the cable retaining clamp located at the junctionbox. Remove generator output wiring from junction box by gently pulling on sheathed cable.8. Support the generator set using a drivetrain removal lift.CAUTIONGenerator set must be supported prior to removal of generator retaining bolts due to the weight of thegenerator set.9. Remove generator (4) retaining bolts. Lower generator set. Remove from vehicle.GENERATOR REPLACEMENT1. Lift generator set into position using a drivetrain remove lift or equivalent.2. Insert (4) generator retaining bolts. Tighten.3. Route sheathed cable to junction box. Insert generator output wiring through the cable connector intojunction box. Connect wiring as noted during removal. Apply wire nuts. Tighten the cable retainingclamp.NOTE: The sheathed protective cable should be firmly seated in the connector. Do NOT apply clamppressure directly to unprotected wires. Install the junction box cover.4. Attach and secure fuel line to fuel filter on generator.5. Connect 12-volt control wiring to connector at generator.6. Connect and secure battery cable to generator.7. Connect and secure tailpipe to generator muffler.8. Connect negative lead to chassis battery.1-21