Perfect Match: Best Management Practices - MCS

More documents

Recommendations

Info

OperationsWhat happens when?Not defining these rules before a job gets started causes majorintegrity problems. What happens when pieces are diverted? Where do the operatorsput them? What happens when pieces get jammed? What happens when the pieces are not feeding well?Where do these pieces end up? Believe it or not, it is very commonfor operators to take a piece that has jammed on an inkjet table, andmanually place it on a conveyor. When does an operator call a setupmechanic? The rules must be defined and followed by everybodyinvolved in the process. Define the procedures.
Slot 1Slot 6Slot 12Jams: Remove, Update, VerifyCameraSlot 2Inserter collatorSlot 16Insert Station Slot 161. When a jam occurs in the system1. Remove the damaged piecesand place them in the “PieceRemoved Bin”.2. Update the Software as to whichpieces have been removed, andwhich pieces are still in thesystem3. Verify at the conveyor after thesystem is turned back on thatthe system is still matching.Slot 19Turn Over Station Slot 19JamInkjet and Camera BaseSlot 19-23Inkjet Slot 22Slot 25Diverter Slot 24
Page 1 and 2: Your customers are paying for highe
Page 3 and 4: Most Common Ways to inadvertently o
Page 5 and 6: PeopleAssign a team for your Camera
Page 7: OperationsWhat is the procedure to
Page 11 and 12: OperationsProcedures for Operators

Perfect Match: Best Management Practices - MCS

Create successful ePaper yourself

Delete template?

Save as template?