Xtrinsic MMA8653FC 3-Axis, 10-bit Digital Accelerometer - Freescale
Xtrinsic MMA8653FC 3-Axis, 10-bit Digital Accelerometer - Freescale
Xtrinsic MMA8653FC 3-Axis, 10-bit Digital Accelerometer - Freescale
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1.4 Recommended application diagram<br />
VDD<br />
<strong>MMA8653FC</strong><br />
SCL<br />
INT1<br />
INT2<br />
VDDIO<br />
1 kΩ<br />
1 μF<br />
.1 μF<br />
BYP<br />
0.1 μF<br />
Note: 1 kΩ pullup resistors on INT1/INT2<br />
are only needed for open-drain.<br />
Figure 4. Application diagram<br />
Table 1. Pin descriptions<br />
Pin # Pin Name Description Notes<br />
Device power is supplied through the VDD line. Power supply decoupling<br />
1 VDD Power supply<br />
capacitors should be placed as near as possible to the pins 1 and 8 of the<br />
device.<br />
2 SCL I 2 7-<strong>bit</strong> I<br />
C Serial Clock<br />
2 C device address is 0x1D.<br />
The control signals SCL and SDA are not tolerant of voltages more than VDDIO<br />
+ 0.3V. If VDDIO is removed, then the control signals SCL and SDA will clamp<br />
any logic signals with their internal ESD protection diodes. The SDA and SCL<br />
I2C connections are open drain, and therefore usually require a pullup resistor.<br />
3 INT1 Interrupt 1<br />
The interrupt source and pin settings are user-programmable through the I 2 C<br />
interface.<br />
4 BYP<br />
Internal regulator output<br />
capacitor connection<br />
5 INT2 Interrupt 2 See INT1.<br />
6 GND Ground<br />
7 GND Ground<br />
8 VDDIO <strong>Digital</strong> Interface Power supply<br />
9 GND Ground<br />
<strong>10</strong> SDA I2C Serial Data See SCL.<br />
Sensors<br />
6 <strong>Freescale</strong> Semiconductor, Inc.<br />
1<br />
2<br />
3<br />
4<br />
5<br />
Top View<br />
<strong>MMA8653FC</strong><br />
<strong>10</strong><br />
9<br />
8<br />
7<br />
6<br />
VDDIO<br />
1 kΩ<br />
0.1 μF<br />
SDA<br />
VDDIO
Change language