TONO-PEN XL Tonometer

More documents

Recommendations

Info

Maintenance & StorageReplace the batteries using the procedure described on page 9. If the instrument isnot to be operated for an extended period of time, remove both batteries. This willavoid possible damage to the instrument due to battery leakageAttachment ScrewThe attachment screw, located on the underside of the instrument, is used to protectthe sensitive electronics against intrusion and should be removed only by themanufacturer.Note: Removal of the Attachment Screw will void the warranty.SpecificationsDimensions 1/4” X 1” X 7/8”WeightRange of Measurement59.4g (2.1 oz.)5 - 80 mmHgPower Source 3V Lithium Manganese Dioxide Batteries (QTY 2)SymbolsATTENTION, SEE INSTRUCTIONS FOR USECATALOG NUMBERSNSERIAL NUMBERDATE OF MANUFACTURELOT NUMBERWASTE OF ELECTRICAL AND ELECTRONIC EQUIPMENTSYMBOLS FOR OCU-FILM ONLYDO NOT REUSE. SINGLE USEPage 18USE BY
TroubleshootingOverviewThis section provides a guide for troubleshooting some basic TONO-PEN XLoperational problems. If a problem persists after using this guide contact Reicherttechnical service.Table 6-1: TONO-PEN XL Troubleshooting GuideSymptom Probable Cause Correction“Lob” Batteries are displayed Low Batteries Replace batteriesNoticeable slowing in thecalibration check process, inactivating instrumentBatteries are lowCompressed air cleaning haslowered the temperature of theinstrumentReplace batteriesAllow TONO-PEN XL unit to warmto room temperatureMultiple inaccurate readings Improper technique Review “Taking a Measurement”section or watch Instructional DVDNo beeps and/or no dashes uponactivationUnable to obtain “Good’ calibrationcheckOld or improperlyapplied Ocu-Film Tip CoverBatteries are lowNeed to check calibrationDebris around probe postMechanical or electronic damageActivation switch not depressedlong enoughIncorrect battery installationBatteries are lowMechanical or electronic damageImproper techniqueDirty transducerReplace Ocu-Film Tip CoverReplace batteriesPerform calibration checkprocedure (see page 11)Clean with compressed gas (seepage 17 for procedure)Arrange for repair through ReichertTechnical ServiceDepress activationswitch longerCheck batteriesReplace batteriesArrange repair through ReichertTechnical ServiceReview page 11 or watchInstructional DVDClean with compressed gas (seepage 17 for procedure)Page 19
Page 1 and 2: TONO-PEN ® XL TonometerUser’s Gu
Page 3 and 4: Table of ContentsIntroduction 4Warn
Page 5 and 6: IntroductionInstruction ManualOCU-F
Page 7 and 8: Warnings and CautionsWARNING: NEVER
Page 9 and 10: SetupOcu-Film Tip Cover - CorrectOc
Page 11 and 12: CalibrationCalibration ProcedureThe
Page 13 and 14: Taking a MeasurementInstrument Prep
Page 15 and 16: Taking a MeasurementNote: Anytime t
Page 17: Maintenance & StorageInstrument Sto
Page 21 and 22: Guidance & Manufacturer’s Declara
Page 23 and 24: WarrantyThis product is warranted b

TONO-PEN XL Tonometer

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?