Benchtop Peristaltic Dispenser Peristaltische Schlauchpumpe

1 Please observe the following1.3 Field of Application (Intended Use)The Benchtop Peristaltic Dispenser 98548 provides volumetric dispensing of nonthixotropicmaterials such as Cyanoacrylates, anaerobics and UV products up to aviscosity of 5,000 mPas without the need of compressed air. It can be used at manualand semi-automatic workplaces.For better dispensing results order the Needle Variety Kit 97262. In the needle kitdispensing needles with different sizes are included.1.4 For Your SafetyFor safe and successful operation of the unit, read these instructions completely. Themanufacturer cannot be held responsible for damage or injury of any kind because ofmisuse or improper application or because of failure to observe safety instructions orwarnings.Be sure to retain this manual for future reference.Refer to the technical data sheet of the assigned adhesive under the addresswww.loctite-equipment.com or request the technical data sheet and the safety datasheet (acc. to the EC Directive 91/155/EC) for the LOCTITE product used atHenkel AG & Co. KGaA+49 89 92 68 11 67 for English version of data sheets;089-92 68 11 22 for German version of data sheets.OrHenkel Corporation1001 Trout Brook CrossingRocky Hill, CT 06067, USAFollow unconditionally the INSTRUCTIONS of these data sheets!While under warranty, the unit may be repaired only by an authorized Henkelservice representative.Warning!If chemical products are not properly handled, damage to health can result!Observe general safety regulations for the handling of chemicals!Observe manufacturer’s instructions!Request a safety data sheet for the LOCTITE ® -product used!Removing, by-pass or putting out of operation of the safety devices can result indamage to health and to the unit and is therefore prohibited!Damage to the power cord or the housing can result in contact with live electricalparts.Check the power cord and the unit before each use.If the power cord or the unit is damaged, do not operate!Replace a damaged power cord with a new one.The unit may be opened and repaired only by an authorized service personal.Do not touch the pump, rolling parts and the rotor’s inner parts while the pump isworking.Check the tube before each use and replace a damaged tube with a new one. Do notuse unspecified tube for the roller.When inner rotor is stuck with liquids, please send it immediately for repairing.5