owner’s manual

JetPaks ® & Jetting
Interchanging JetPaks
NOTE: Due to its large amounts of plumbing and
jets, the NeckBlaster and Neck Masseuse JetPaks
will only fit in the Lounger or Recliner (corner seats).
Step 1: Put the spa in Standby mode, this will
prevent the pump(s) from activating (see Control
System).
Step 2: Carefully, remove the head rest and
SnapCap by lifting upwards.
Step 4: Loosen the two PVC unions, pull the
manifold out from in between the two water
unions and remove the JetPak from the JetPod .
Step 5: Disconnect the air line union.
Step 6: Exchange JetPaks ® .
Step 7: Reattach the JetPaks by reversing steps
NOTE: When changing JetPaks, be aware that
spa models with two pumps have an orange plug
called a JetZone Divider factory installed in the
mainchannel pipe either between seats 2 & 3 (for
models 462, 562, 552) or between seats 3 & 4
(for models 662 & 682). Ensure this JetZone
Divider remains in place during JetPak changing.
This JetZone Divider isolates water being
pumped frompump 1 from water being pumped
by pump 2, and must remain in place for proper
spa operation. Never operate a two pump spa
without a JetZone Divider in place as serious
damage to the pump(s) may occur. If you are
missing this divider or have questions, please call
your authorized Bullfrog Dealer.
Step 3: Push the JetPak forward until you have
enough room to reach the two PVC water unions
and air-line union.
16