owner’s manual
owner's manual - Bullfrog Spas
owner's manual - Bullfrog Spas
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
To Refill Your Spa:<br />
WARNING: When refilling the spa, always<br />
Super Sanitize the new water by adhering to the<br />
instructions in the Water Chemistry section.<br />
Step 1: To avoid air pockets in the pump(s), refill<br />
the spa with water by placing the hose into the<br />
filter compartment through the Weir door. Fill to<br />
the water level indication on the faceplate of the<br />
filter assembly.<br />
Step 2: Restore electrical power supply.<br />
Step 3: Press any button to reset the control<br />
system.<br />
Step 4: Reattach the equipment compartment<br />
door.<br />
Step 5: Following instructions in Starting the Spa<br />
with New Water.<br />
NOTE: The higher the water level in the spa, the<br />
fewer spa users it will be able to handle.<br />
Filter Cleaning<br />
It is recommended that the filter cartridge(s) be<br />
cleaned every 3-6 weeks or as needed. Replace<br />
the filter cartridge(s) every 1-2 years or when<br />
necessary.<br />
To maintain warranty protection, use only<br />
genuine Bullfrog Filter Cartridge replacements.<br />
To clean your filter cartridge(s), complete the<br />
following:<br />
CAUTION: Never operate spa with the<br />
filter(s) removed.<br />
Step 1: Place the spa in Standby mode.<br />
Step 2: Remove FilterCap .<br />
Step 3: Remove cartridge(s).<br />
Step 4: Using a garden hose with a nozzle or<br />
other high-pressure device, clean cartridge(s).<br />
Work top to bottom on each pleat.<br />
• To remove collected suntan lotions or body oils,<br />
soak cartridge(s) in warm water with a Filter<br />
Cleaner or detergent.<br />
• To remove calcium deposits, soak cartridge(s) in<br />
a plastic container using a 1:10 ratio of Muriatic<br />
acid to water solution. Calcium deposits indicate<br />
a high spa pH, which should be corrected.<br />
Step 5: Reinstall cartridge(s) and FilterCap.<br />
Step 6: Press any button to reset the control<br />
system.<br />
IMPORTANT: Using a brush to clean a filter<br />
cartridge could cause damage to the cartridge.<br />
22