SKF - Spherical Plain Bearings and Rod Ends
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Rod</strong> ends requiring<br />
maintenance<br />
Steel/steel <strong>and</strong> steel/bronze rod ends require<br />
lubrication. To facilitate this:<br />
Relubrication facilities for steel/steel rod ends<br />
Fig. 5<br />
1<br />
• All <strong>SKF</strong> steel/steel rod ends, with the exception<br />
of small-sized E <strong>and</strong> ESA design rod ends,<br />
can be relubricated via a lubrication hole or<br />
grease fitting in the rod end housing as well<br />
as via the pin <strong>and</strong> the inner ring († fig. 5).<br />
• All <strong>SKF</strong> steel/bronze rod ends can be<br />
relubricated via a lubrication hole or grease<br />
fitting in the rod end housing († fig. 6).<br />
The general recommendations for steel/steel<br />
radial spherical plain bearings also apply to<br />
steel/steel rod ends as well as steel/bronze rod<br />
ends.<br />
For steel/bronze rod ends in the SIKAC .. M <strong>and</strong><br />
SAKAC .. M series, <strong>SKF</strong> recommends <strong>SKF</strong> LGMT 3<br />
grease († table 1 on page 87). Lithium based<br />
greases with a normal consistency without solid<br />
lubricant additives can also be used.<br />
Lubrication hole<br />
Grease fitting<br />
Relubrication facilities for steel/bronze rod ends<br />
(sizes 6 <strong>and</strong> larger)<br />
Fig. 6<br />
Maintenance-free rod ends<br />
Maintenance-free, self-lubricating rod ends are<br />
designed to be used as dry sliding bearings <strong>and</strong><br />
must not be lubricated. Consequently, these rod<br />
ends do not have a relubrication facility in their<br />
housings.<br />
Steel/PTFE FRP rod ends are an exception.<br />
They can be used without additional lubricant,<br />
but their service life can be extended appreciably<br />
if they are lubricated prior to use.<br />
CAUTION: Depending on their design, <strong>SKF</strong> rod<br />
ends are either completely or partially coated<br />
with an oily preservative or filled with grease.<br />
Avoid skin contact as these substances may<br />
cause skin irritation or an allergic reaction.<br />
SIKAC .. M series<br />
SAKAC .. M series<br />
89