Installation Guide Pulpmatic Ultima & Eco V3.0
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Move the plinth body into position. Fit the plinth body to the floor using either M8 anchor bolts or<br />
silicone sealant as an ahesive where appropriate.<br />
Apply sealant to<br />
these faces<br />
marked in green<br />
The red rings show<br />
the fixing holes for<br />
floor anchor bolts.<br />
Slide the machine onto the plinth body by first tilting the machine then slidding it on top of the<br />
plinth.<br />
Align machine corners with the<br />
corners of the plinth<br />
With the machine now on top of the plinth body align the holes in the base of the machine with the<br />
2 threaded holes at the rear of plinth. Once algined fit 2 of the M8x20LG hex bolts with M8 spring<br />
and flat washers into the holes. Tighten these to finger tight at this stage.<br />
Copyright © 2015 DDC Dolphin Ltd Page 22 of 50 October 15 IG-UECO-<strong>V3.0</strong>