Installation Guide Pulpmatic Ultima & Eco V3.0

More documents

Recommendations

Info

Incorrect Incorrect Correct Fully tighten Copyright © 2015 DDC Dolphin Ltd Page 26 of 50 October 15 IG-UECO-<strong>V3.0</strong>
6.7 Remove materials from chamber Connect the machine to an electrical outlet (this can be a temporary supply for this task) Allow the machine time to power up (45 seconds) Place foot into foot cup to activate lid operation Allow the lid to fully open Unpack items stored in the chamber Very gently push the lid down, auto close will take over Allow lid to close and lock then turn OFF the electrical supply 6.8 Remove the protective film The stainless steel sections of the machine have a protective layer of plastic film. This must peeled away from the machine. Take care to remove all of the film leaving no torn edges. Use a safe sharp knife to remove any flakes or remnants of plastic. 6.9 Check internal parts Check the electrical supply is turned OFF. Remove front panel and visually inspect the internal parts of the machine for any damaged or loose parts. Check all bolts and fixings for the internal parts and components. 6.10 Cold water connection Water hose connection This machine is supplied with a 1.5m flexible water hose fitted with a female ¾ “B.S.P. threaded fitting”, a suitable cold water supply outlet is required. The hose connection tap MUST be within 1 meter of the machine & easily accessible to the operator of the machine. Copyright © 2015 DDC Dolphin Ltd Page 27 of 50 October 15 IG-UECO-<strong>V3.0</strong>
Page 1 and 2: Installation Guide Pulpmatic® Ulti
Page 3 and 4: 6.23 Cover and protect machine unti
Page 5 and 6: 3. Application This manual should b
Page 7 and 8: 4. Delivery of the machine As the m
Page 9 and 10: All DDC Dolphin Ltd machines must b
Page 11 and 12: All dimensions in millimetres (mm)
Page 13 and 14: 6.2 Manual handling Use safe workin
Page 15 and 16: Unclip the wiring loom from the foo
Page 17 and 18: The plinth is not pushed back far e
Page 19 and 20: Only remove rubber mat if fitting t
Page 21 and 22: 6.6 (Optional) plinth with extended
Page 23 and 24: M8 x 20LG locations Plinth fixing l
Page 25: Push the plinth down after locating
Page 29 and 30: Double check valve/non return valve
Page 31 and 32: Height of waste and soil pipe The c
Page 33 and 34: Rodding points Rodding points shoul
Page 35 and 36: Typical service arrangement Overflo
Page 37 and 38: Drain rodding facility close to mac
Page 39 and 40: Turn the electrical supply ON at th
Page 41 and 42: 6.17 Assemble the chemical system I
Page 43 and 44: 7. Request DDC Dolphin Ltd agent to
Page 45 and 46: 9. Installation materials The follo
Page 47 and 48: 10. Summary requirements C
Page 49 and 50: 10.2 Specifications single phase 38

Installation Guide Pulpmatic Ultima & Eco V3.0

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?