nsx_60_cli

Chapter 3 NSX CLI Commands
Example
nvp-controller # show control-cluster startup-nodes
10.24.105.59
show control-cluster status
Shows control‐cluster status. The example below shows that the controller status is normal. All controllers in
the cluster should have the same cluster ID as the first controller.
Synopsis
show control-cluster status
Example
nvp-controller # show control-cluster status
Type Status Since
--------------------------------------------------------------------------------
Join status: Join complete 08/15 00:39:57
Majority status: Connected to cluster majority 08/15 00:39:33
Restart status: This controller can be safely restarted 08/15 00:40:03
Cluster ID: 2105ad76-0449-47ef-9f99-83e7ddd14cd0
Node UUID: 2105ad76-0449-47ef-9f99-83e7ddd14cd0
Role Configured status Active status
--------------------------------------------------------------------------------
api_provider enabled activated
persistence_server enabled activated
switch_manager enabled activated
logical_manager enabled activated
directory_server enabled activated
show network interface
Shows the IP address of the controller.
Synopsis
show network interface
CLI Mode
Basic, Privileged
ESXi CLI Commands
This section describes the ESXi CLI commads for NSX vSphere. For additional ESX CLI commands, see vSphere
Command‐Line Interface Documentation.
esxcli network vswitch dvs vmware vxlan config stats get
Shows statistics.
Synopsis
esxcli network vswitch dvs vmware vxlan config stats get
Example
# esxcli network vswitch dvs vmware vxlan config stats get
Level: 1
esxcli network vswitch dvs vmware vxlan config stats set
Enable statistics. Adding level=0 disables statistics.
VMware, Inc. 81