10.04.2019 Views

ssur Prosthetic Catalogue 2019

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

ICEROSS ® TRANSTIBIAL LINERS BY ÖSSUR<br />

Careful selection of the Iceross liner is required to produce maximum benefit to the user. When selecting the appropriate transtibial Iceross<br />

liner the following must be considered:<br />

1. Size of the residual limb<br />

2. Activity/Impact level of the user<br />

3. Use of fitting aids<br />

4. Profile<br />

5. Fitting Aid<br />

ÖSSUR LINERS<br />

AND SOCKETS<br />

1. SIZE<br />

With the tissue of the residual limb hanging down, measure 4cm proximal to the distal end of the limb<br />

and mark this point on the skin. Measure the circumference of the limb at this point with medium<br />

tension on the tape measure.<br />

Iceross size 25cm<br />

User measurement 26cm<br />

The measurement taken corresponds to the size of Iceross to be used. Select the liner size matching your measurement or, if between sizes,<br />

select the next size below. Do not select a size larger than your measurement or more than one size below the measurement. E.g. if the<br />

circumference of the limb measures 26cm, select Iceross size 25.<br />

NOTE - ICEROSS LOCKING LINERS:<br />

The incorporated size-specific umbrella works in conjunction with the matrix. Optimal function of both the umbrella and matrix is dependent<br />

on correct size selection of the Iceross liner. Incorrect sizing may cause discomfort to the user, perspiration and reduced control of the<br />

prosthesis.<br />

NOTE - ICEROSS SEAL-IN LINERS:<br />

For Iceross Seal-In liners, it is essential that the Hypobaric Sealing Membrane (HSM) sits correctly against the liner around its full<br />

circumference. Once you have selected the liner according to our instructions, assess the membrane according to the pictures below, visually<br />

and manually. Picture 3 is the optimal situation. In some cases, the next size down may need to be selected to achieve this fitting (this is unique<br />

to Iceross Seal-In liners and should not be applied to other Iceross models, including the Iceross Seal-In X5 and Seal-In V liners).<br />

1. LINER IS TOO SMALL 2. LINER IS TOO BIG<br />

3. LINER FITS CORRECTLY<br />

The sizing recommendations are intended as a guide. There may be occasions when alternative sizes need to be selected.<br />

23<br />

WWW.OSSUR.COM

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!