Piaggio-Typhoon-50-EN _Service Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Electrical system <strong>Typhoon</strong> <strong>50</strong><br />
F. Fuel level indicator<br />
G. Rev counter<br />
H. Low fuel warning light<br />
Instruments and warning lights control board<br />
A= High beam warning light;<br />
B= Mixer oil reserve warning light;<br />
C= Turn indicator warning light;<br />
D= Low fuel warning light;<br />
E= Headlight warning lights;<br />
F= Rev counter;<br />
M= Odometer<br />
N= Speedometer;<br />
P= Coolant temperature indicator (not available on<br />
this model);<br />
S= Fuel level indicator;<br />
Checks and inspections<br />
Checks to be made in the case of ignition irregularities and/or no spark on the spark plug<br />
1. Check the condition of the spark plug (clean it with a metal brush, remove the encrustations, blast<br />
it with compressed air and, if necessary, replace it).<br />
2. Without removing the stator, carry out the following checks:<br />
After visually checking the electrical wiring, perform measurements on the loading reel, the pickup (see<br />
chart) and the continuity using the appropriate tester.<br />
If checks on the loading reel, pickup and continuity show abnormalities, replace the stator; otherwise<br />
replace the central unit. Remember that disconnections due to replacement of the central unit must be<br />
done with the engine off.<br />
Specific tooling<br />
020331Y Digital multimeter<br />
CHECK ON THE PICK UP<br />
Specification<br />
Desc./Quantity<br />
1 Red and white cable 90±140 ohm<br />
ELE SYS - 46