ALxxF Microwave Radio Indoor Unit (IDU) Users Manual - Meconet

More documents

Recommendations

Info

DC Power F1 F2 ODU Power Alarm Fault CLI Modem OH/Hsby Eth Mgmt Eth Mgmt Eth 1 Eth 2 T1/E1 P1 T1/E1 P2 T1/E1 P3 T1/E1 P4 Figure 2 ALXXF Front Panel ALCOMA Proprietary Page 6 of 16
1.2. Front Panel Interfaces 1.2.1. T1/E1 Ports The T1/E1 ports are 8-pin modular jacks with standard RJ-48 pinouts as shown in Figure 3 and Table 1 below. Transport mode is software configurable to support one to four T1 channels or 1 to 4 E1 channels. Lines are matched to 100 ohm in T1 mode and 120 ohm in E1 mode. Figure 3 Pin Definition for 8-pin Modular Jack (as seen looking into the port) 1.2.2. Ethernet Transport Ports Pin Signal Name 1 RX, Ring, - 2 RX, Tip, + 3 Shield/Return/Gnd 4 TX, Ring, - 5 TX, Tip, + 6 Shield/Return/Gnd 7 NC 8 NC Table 1 T1/E1 RJ-48 Pinout The two Ethernet transport ports (Enet-1 and Enet-2) provide 10/100BaseT interfaces with standard RJ-45 pinouts. When the <strong>IDU</strong> is properly configured, the <strong>IDU</strong> provides transport of Ethernet frames ingressed at these ports over the link to the far side radio. An internal Ethernet switch also provides layer 2 switching functions between these two ports and the far side terminal. The Ethernet PHYs provide MDI/MDI-X cross-connect with auto-detect, so both straight-thru and cross cables are accommodated to any other 10/100 Base- T interface. Ethernet transport is configurable up to 130 Mbps. Note that Ethernet transport will be enabled with a coming firmware update. ALCOMA Proprietary Page 7 of 16
Page 1 and 2: ALxxF Microwave Radio Indoor Unit (
Page 3 and 4: 1. ALxxF Product Description 1.1. O
Page 5: ODU I/F (N-Type) BPF BPF BPF BPF LP
Page 9 and 10: Pin Signal Name Description 1 Chass
Page 11 and 12: For negative voltage operation: •
Page 13 and 14: 2. Setup and Operation To setup a l
Page 15 and 16: 3. CLI Text Menu Control and Status

ALxxF Microwave Radio Indoor Unit (IDU) Users Manual - Meconet

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?