Output Push-pull - Hengstler

More documents

Recommendations

Info

SHAFT ENCODERS WITH SYNCHRO FLANGE SHAFT ENCODERS WITH SQUARE FLANGE SHAFT ENCODERS WITH ROUND FLANGE Examples of Flange Mounting The shaft encoders with synchro flange can be installed in two ways: • by means of the synchro flange and three clamping eccentrics (see “Accessories”), • by means of the fastening threads provided on the face. The encoder is centered by means of the centering collar on the flange. Clamping eccentric Mounting bell The shaft encoders with square flange can be installed in two ways: • by means of the fastening threads provided on the face, • by means of an angle bracket. The encoder is centered by means of the centering collar on the flange. Mounting by fastening threads The shaft encoders with round flange can be installed in two ways: • by means of the fastening threads provided on the face, • by means of an angle bracket. The encoder is centered by means of the centering collar on the flange. Angle bracket Mounting by fastening threads Angle bracket ENCODERS COUNTERS CONTROLLERS INDICATORS RELAYS PRINTERS CUTTERS Shaft Encoders 2001 53
SHAFT ENCODERS WITH HOLLOW SHAFT (RI 58-H) SHAFT ENCODERS WITH HOLLOW SHAFT (RI 58-D/G) SHAFT ENCODERS WITH SOLID SHAFT Examples of Flange Mounting a) Mounting by screws 1 Hollow-shaft encoder 2 “B”-side of drive shaft 3 Fastening screws (M4) Mounting of version F, D (Clamping shaft) 1 Torque spring 2 Clamping ring with cross-recess screw 3 Straight pin 4 Actuating shaft b) Mounting by clamping eccentrics 1 Hollow-shaft encoder 2 “B”-side of drive shaft 3 Clamping eccentrics 4 Fastening screws Mounting of version E (Blind shaft) 1 Torque spring 2 O-ring 3 Straight pin 4 Actuating shaft with threaded bore 5 M4-screw with spring washer 6 Cap Connection of solid-shaft encoders to the shaft is by means of a coupling. The coupling compensates for axial movements and lack of alignment between the shaft encoder and the drive shaft, thus preventing excessive bearing loads on the encoder shaft. For further details please refer to heading “Accessories”. 54 Shaft Encoders 2001 ENCODERS COUNTERS CONTROLLERS INDICATORS RELAYS PRINTERS CUTTERS
Page 1 and 2: SINGLE-CHANNEL SHAFT ENCODERS TWO-C
Page 3: FLANGE TYPE OVERVIEW SHAFT ENCODERS
Page 7 and 8: OUTPUT CIRCUIT TECHNICAL DATA Outpu
Page 9 and 10: OUTPUT CIRCUIT TECHNICAL DATA FUNCT
Page 11: Type RI 30, 32, 36, 38, 41, 42, 58,

Output Push-pull - Hengstler

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?